Design and construction of a test set-up for the determination of performance characteristics of compact heat exchangers

Download
056827.pdf
1996
Güzel, Mithat Tolga
Show full item record
76
views
0
downloads
https://hdl.handle.net/11511/10050
Graduate School of Natural and Applied Sciences, Thesis

Suggestions

Design, construction and testing of a test set-up for evalutaing performance of hydraulic pumps.
Alagök, Nejat; Department of Mechanical Engineering (1979)
Design and construction of two complementary experimental setups for the instruction of conductive and convective heat transfer.
Aksan, Şefik Nusret; Department of Mechanical Engineering (1969)
Design and construction of an interferometric setup for dynamic measurement of clearances inside plain bearings
Jafari-Tabrizi, Atae; Dursunkaya, Zafer; Department of Mechanical Engineering (2017)
In this work with the help of fiber optic interferometry an experimental framework is designed and constructed to dynamically measure micron-level clearances inside main journal bearing of an engine crankshaft, and the trajectory of its shaft. For this purpose, the crankshaft is rotated at lower speeds than its operating speeds. An electric motor is used to rotate the crankshaft, and there are no pistons and connecting rods connected to the crankpins. Measured clearances from multiple points of the bearing ...
Design and construction of a four channel PDM-OOK telemetry transmitter for process variables.
Bozdağ, Erdal; Department of Electrical Engineering (1979)
Design and construction of an educatinal pump bench with operational controls
Güner, Berkay; Albayrak, Kahraman; Department of Mechanical Engineering (2004)
System characteristics of automated pumping systems may change due to wear, aging of piping, and accumulation of deposits in the system and/or due to configuration changes. Such changes might result in conflicts between the controlling algorithms and the actual system requirements for each particular case. The said mismatch between the actual physical system and the software controlling it, may result in inefficient operation of the pump which may even lead to total system failures (overpressurization of in...
Citation Formats
M. T. Güzel, “Design and construction of a test set-up for the determination of performance characteristics of compact heat exchangers,” Middle East Technical University, 1996.
METU IIS - Integrated Information Service open@metu.edu.tr