Comparison of load and resistance factor design and TS 648 for structural members

Download

056604.pdf

Date

1996

Author

Nuhoğlu, Çagatay

Metadata

Show full item record

Item Usage Stats

80
views

0
downloads

URI

https://hdl.handle.net/11511/10344

Collections

Graduate School of Natural and Applied Sciences, Thesis

Suggestions

OpenMETU
Core

Comparison of TS 648, load and resistance factor design and EUROCODE 3: Part 1.1 for design fundamentals and structural members Kuyucuk, Ali Onur; Yılmaz, Çetin; Department of Civil Engineering (1999)
Comparison of 1-D and 3-D Modeling Methodologies for Flat-Grooved Heat Pipes Gökçe, Gökay; Altunkaş, Oğuz; Çetin, Barbaros; Dursunkaya, Zafer (2019-09-03)
Comparison of continuous and pulsed pump and treat for mass transfer limited aquifers Aksoy, Ayşegül (2004-01-01)
Comparison of compressive strength test procedures for blended cements Ülker, Elçin; Yaman, İsmail Özgür; Öztürk, Abdullah; Department of Cement Engineering (2010) The aim of this thesis is to twofold, in order to demonstrate the variabilities that can be faced within the compressive strength of blended cements, one blended cement namely CEM IV / B (P-V) 32.5N is selected and the 28-day compressive strength is obtained by 16 different laboratories following TS EN 196-1 standard. Later, to show the variabilities that could be faced by different standards, three different cement types were selected and their compressive strengths are determined following two procedures ...
Comparison of ASCE/SEI Standard and modal pushover-based ground motion scaling procedures for pre-tensioned concrete bridges Özgenoğlu, Müge; Arıcı, Yalın (2017-01-01) Complex analysis methods such as non-linear time-history analyses (NTHA) are often required for the design of non-standard bridges. The selection of the ground motions for the NTHA is a crucial task as the results of the analyses show a wide variability according to the selected records. In order to predict the demand in accordance with the seismic hazard conditions of the site, the selected motions are usually modified by scaling procedures. Within this context, the performance of two scaling methods, name...

Citation Formats

Ç. Nuhoğlu, “Comparison of load and resistance factor design and TS 648 for structural members,” Middle East Technical University, 1996.