A study on the comparison of methods measuring human power ooutput during high intensity short duration exercises

Download
021645.pdf
1992
Cinemre, Alpan
Show full item record
112
views
0
downloads
https://hdl.handle.net/11511/10481
Graduate School of Social Sciences, Thesis

Suggestions

A study on microstructural characterization of the interface between apatite-wollastonite based glass ceramic and feldspathic dental porcelain
PEKKAN, Gürel; PEKKAN, KERİMAN; PARK, JONGEE; Öztürk, Abdullah (2016-12-01)
In this study, the contact area between the glass ceramic containing apatite [Ca-10(PO4)6(O,F-2)] and wollastonite [CaO center dot SiO2] crystals (A-W glass ceramic) and feldspathic dental porcelain was characterized using scanning electron microscope and energy dispersive spectroscopy. Alumina-added A W glass ceramics were prepared by sintering glass compacts in the MgO-CaO-SiO2-P2O5-Al2O3 system at 1100 degrees C. Commercially available dental porcelains for alumina frameworks were applied on the A-W glas...
A study on multi objective optimization applications used to optimize building shape for energy efficiency
Yılmaz, Deniz Derya; Tanyer, Ali Murat (null; 2019-07-01)
A study on the reliability-based safety analysis of hardfill dams
Kitapcıgil, Sülen Nur; Yanmaz, Ali Melih; Kentel Erdoğan, Elçin; Department of Civil Engineering (2010)
Dams are important large structures providing vital benefits to human life. These strategic structures are necessary in order to supply water and energy and to control floods. Moreover, dams have important roles in regional development and national economy. Thus, the design of dams deserves rigorous studies. Deterministic approach may be acceptable for design of dams and may satisfy safety requirements if large safety factors are used. However, such an approach will not be cost-effective in economic terms. ...
A comparative study on the nonlinear behavior of chevron and suspended zipper braced steel frames
Özçelik, Ahmet Yiğit; Sarıtaş, Afşin; Department of Civil Engineering (2010)
Chevron braced steel frames require large beams to redistribute the unbalanced vertical forces exerted on the beams after brace buckling. A new frame configuration similar to chevron brace was proposed in literature, where zipper columns were attached between mid-spans of the beams from second to top story. During severe ground motion, the unbalanced vertical forces caused by buckling of lower story braces are in this case redistributed to the upper story braces by these zipper columns. Consequently, all st...
A study on the reliability-based safety analysis of concrete gravity dams
Beşer, Mehmet Reşat; Yanmaz, Ali Melih; Department of Civil Engineering (2005)
Dams are large hydraulic structures constructed to meet various project demands. Their roles in both environment and the economy of a country are so important that their design and construction should be carried out for negligibly small risk. Conventional design approaches are deterministic, which ignore variations of the governing variables. To offset this limitation, high safety factors are considered that increase the cost of the structure. Reliabilityاbased design approaches are probabilistic in nature ...
Citation Formats
A. Cinemre, “A study on the comparison of methods measuring human power ooutput during high intensity short duration exercises,” Middle East Technical University, 1992.
METU IIS - Integrated Information Service open@metu.edu.tr