Effect of gtaw parameters on mechanical and microstructural properties of weld joints of low alloy AISI 4130 steel

Download
2001
Ataman, Erkan

Suggestions

Effect of operating parameters on performance of additive/ zeolite/ polymer mixed matrix membranes
Oral, Edibe Eda; Yılmaz, Levent; Kalıpçılar, Halil; Department of Chemical Engineering (2011)
Membrane based separation techniques have been widely used and developed over decades. Generally polymeric membranes are used in membrane based gas separation; however their gas separation performances are not sufficient enough for industrial feasibility. On the other hand inorganic membranes have good separation performance but they have processing difficulties. As a consequence mixed matrix membranes (MMMs) which comprise of inorganic particles dispersed in organic matrices are developed. Moreover, to enh...
Effect of welding parameters on the hot cracking behavior of 7039 aluminum - zinc alloy
Akkuş, Mert; Gürbüz, Rıza; Batıgün, Caner; Department of Metallurgical and Materials Engineering (2010)
7039 aluminum alloys are widely being used in the aerospace, automotive and defense industries in which welding technique is used for their joining. The main problem encountered during the welding of 7039 aluminum alloy is hot cracking. The aim of this study is to understand the effect of welding parameters on the hot cracking behavior of 7039 aluminum alloy by using Modified Varestraint Test (MVT) with Gas Tunsgten Arc Welding (GTAW) technique. During tests, welding speed was selected as varying parameter,...
Effect of cold rolling and annealing parameters on the microstructure and mechanical properties of dual phase steels
Poyraz, Okan; Ögel, Bilgehan; Department of Metallurgical and Materials Engineering (2020)
This study consists of change in the microstructure and mechanical properties of the 0.14C-1.98Mn steel with different cold rolling ratios, annealing temperature and annealing time. The starting sheet metal is 2.8mm thick and have a microstructure of ferrite-pearlite in as-received condition. Samples are cold rolled such that either 30%, 45% or 60% cold rolling is achieved. In order to see the change in microstructure below and in the intercritical temperatures, samples are annealed for 5 minutes or 10 minu...
Effect of tube spinning and subsequent heat treatments on strength, microstructure and residual stress state of AISI/SAE type 4140 steel
Gür, Cemil Hakan (Informa UK Limited, 2003-11-01)
In the present study, the effects of deformation percentage (23, 30, 50 and 66%) and subsequent stress relief and tempering heat treatments on the mechanical properties, residual stress state and microstructure of AISI/SAE type 4140 steel tubes manufactured by forward spinning were evaluated. Mechanical properties were determined by means of hardness and tensile tests. The tangential component of the surface residual stresses was determined by a slitting method. Plastic deformation of the metal during spinn...
Effect of process parameters on physical and mechanical properties of RTM (resin transfer molded) parts
Akgül, Tiğmur; Parnas, Levent; Department of Polymer Science and Technology (1998)
Citation Formats
E. Ataman, “Effect of gtaw parameters on mechanical and microstructural properties of weld joints of low alloy AISI 4130 steel,” Middle East Technical University, 2001.