Control of radiation by dipole arrays using dielectric cylinder loading

Download
029595.pdf
1993
İçtihadi, Ali Rıza
Show full item record
68
views
0
downloads
https://hdl.handle.net/11511/11861
Graduate School of Natural and Applied Sciences, Thesis

Suggestions

Control of Planar Spring-Mass Running Through Virtual Tuning of Radial Leg Damping
Secer, Gorkem; Saranlı, Uluç (Institute of Electrical and Electronics Engineers (IEEE), 2018-10-01)
Existing research on dynamically capable legged robots, particularly those based on spring-mass models, generally considers improving in isolation either the stability and control accuracy on the rough terrain, or the energetic efficiency in steady state. In this paper, we propose a new method to address both, based on the hierarchical embedding of a simple spring-loaded inverted pendulum (SLIP) template model with a tunable radial damping coefficient into a realistic leg structure with series-elastic actua...
Control of BLDC Motor in Presence of Static Rotor Eccentricity
Shakouhi, S. Mohammad; Mohamadian, Mustafa; Afjei, S. Ebrahim (2011-09-10)
BLDC motors are one of the motor types rapidly gaining popularity. In recent years various researches have been done in the field of motor fault detection and fault tolerant control. However, in the case of rotor problems, especially rotor eccentricity tolerant control a few papers have been presented. Since in sensitive industries, continuous operation with good performance till the maintenance time is very important, operating in the desired condition in presence of this kind of fault is really advantageo...
Control of Hopping Through Active Virtual Tuning of Leg Damping for Serially Actuated Legged Robots
SEÇER, Gorkem; Saranlı, Uluç (2014-06-07)
Spring-mass models have been very successful both in describing and generating running behaviors. Control of system energy within these models takes different forms, among which the use of a linear actuator in series with the leg spring has been preferred by many recent monopedal and bipedal platform designs due to its relative robustness and simplicity. However, the validity of the well-known Spring-Loaded Inverted Pendulum (SLIP) model of running for such platforms can only preserved under a specific fami...
Control of macrostructure in deformation processing of metal/metal laminates
Yazar, O; Ediz, T; Öztürk, Tayfur (2005-01-01)
A study was carried out on model systems deformed under plane-strain. Finite element analysis was used to examine continuously and discontinuously layered models, in which the reinforcement to matrix flow stress ratio, r(s), was varied within the range 1.5 < r(s) < 10. It was found that, for homogeneous refinement of continuously reinforced laminates, the critical value of r(s) is approximately 2. This value, valid for the ideal plastic case, can be increased to a maximum value of r(s) approximate to5 with ...
Control of the thickness distribution of evaporated functional electroceramic NTC thermistor thin films
Schmidt, R.; Parlak, Mehmet; Brinkman, Am (Elsevier BV, 2008-04-01)
In this work the thickness distribution of NTC thermistor thin films produced by low deposition rate (0.8 nm s(-1)) electron-beam evaporation is investigated. The target preparation, deposition conditions and geometrical set-up of the evaporation mechanism are described in detail. The evaporation geometry is shown to be critical for the thickness distribution of evaporated films. The film thickness distribution of evaporated layers was measured across a macroscopic film surface using Alpha Step stylus profi...
Citation Formats
A. R. İçtihadi, “Control of radiation by dipole arrays using dielectric cylinder loading,” Middle East Technical University, 1993.
METU IIS - Integrated Information Service open@metu.edu.tr