Damage tolerance life estimation of critical parts of a fighter aircraft

Download
012809.pdf
1991
Akyürek, Turgut
Show full item record
65
views
106
downloads
Fighter planes, Airplanes, Military, Metals
https://hdl.handle.net/11511/11972
Graduate School of Natural and Applied Sciences, Thesis

Suggestions

Structural analysis of a jet trainer cockpit
Altuğ, Muhittin Nami; Şahin, Melin; Department of Aerospace Engineering (2011)
This thesis presents structural analysis of a cockpit of a jet trainer type aircraft and the correlation studies performed by using ground pressurisation test results. For this purpose, first the response of the complex integrated fuselage structure is investigated under the complex type cabin pressure load. Then, cockpit part of the fuselage structure is modelled using commercial finite element software MSC/PATRAN® and MSC/NASTRAN®. The finite element model (FEM) of the cockpit structure is improved by the...
Breakage characteristics of cement components
Avşar, Çağatay; Hoşten, Çetin; Department of Mining Engineering (2003)
The production of multi-component cement from clinker and two additives such as trass and blast furnace slag has now spread throughout the world. These additives are generally interground with clinker to produce a composite cement of specified surface area. The grinding stage is of great importance as it accounts for a major portion of the total energy consumed in cement production and also as it affects the quality of composite cements by the particle size distribution of the individual additives produced ...
Air data system calibration for military transport aircraft modernization program
Özer, Hüseyin Erman; Özgen, Serkan; Department of Aerospace Engineering (2013)
This thesis presents the calibration processes of the pitot-static system, which is a part of the air data system of a military transport aircraft through flight tests. Tower fly-by method is used for air data system calibration. Altitude error caused by the position of the static port on the aircraft is determined by analyzing the data collected during four sorties with different weight, flap and landing gear configurations. The same data has been used to determine the airspeed measurement error. It has be...
Effects of granulated blast furnace slag trass and limestone fineness on the properties of blended cements
Delibaş, Tuğhan; Yaman, İsmail Özgür; Hoşten, Çetin; Department of Cement Engineering (2012)
The aim of this research was to determine the effects of the fineness of different mineral additives on loss on ignition, heat of hydration, physical, mechanical and chemical properties of blended cements. For that purpose, portland cement clinker was replaced with granulated blast furnace slag (GBFS), natural pozzolan (NP) and limestone (L) at 6%, 20% and 35% replacement levels. Blended cements containing GBFS and NP were ground to a fineness of 3000, 5000 and 6000 cm2/g. Cements containing L were ground t...
Properties of alinite cement produced by using soda sludge
Kesim, Asli Gunes; Tokyay, Mustafa; Yaman, İsmail Özgür; Öztürk, Abdullah (2013-04-01)
A production route of alinite cement clinker using the waste material of the Solvay process of the soda industry as the main raw material was searched. Soda sludge (73.5 wt%), clay (26.3 wt%) and minor amounts of iron ore (0.2 wt%) were mixed to obtain a raw mix that is later burned at nine different burning schemes. Four different burning temperatures (1050, 1100, 1150 and 1200 degrees C) and three different burning durations (60, 90 and 180 min) were applied for clinkerisation. The clinkers obtained were ...
Citation Formats
T. Akyürek, “Damage tolerance life estimation of critical parts of a fighter aircraft,” Ph.D. - Doctoral Program, Middle East Technical University, 1991.
METU IIS - Integrated Information Service open@metu.edu.tr