Pb(Zr0.52Ti0.48)O3 films on stainless steel by chemical solution deposition

Download
2002
Yıldırım, Faruk Altan

Suggestions

Pb(Zr0.52Ti0.48)O3 films on stainless steel by chemical solution deposition
Özenbaş, Ahmet Macit (Trans Tech Publications Ltd; 2004-01-01)
The present work describes the preparation of Pb(Zr0.52Ti 0.48)O3 thin films by chemical solution deposition. Lead acetate, zirconium propoxide and titanium isopropoxide were used as starting materials. Substrates used were stainless steel foils of 0.025 mm thick (AISI 304). The preparation of stock solution and heat treatment procedure was described. Crack-free films were obtained by multilayer coating in which the viscosity of the solution was adjusted such that each layer was approximately 0.2 μm thick. ...
Pb(Zr0.52Ti0.48)O-3 films on stainless steel by chemical solution deposition
Özenbaş, Ahmet Macit (2004-01-01)
The present work describes the preparation of Pb(Zr0.52Ti0.48)O-3 thin films by chemical solution deposition. Lead acetate, zirconium propoxide and titanium isopropoxide were used as starting materials. Substrates used were stainless steel foils of 0.025 mm, thick (AISI 304). The preparation of stock solution and heat treatment procedure was described. Crack-free films were obtained by multilayer coating in which the viscosity of the solution was adjusted such that each layer was approximately 0.2 mum thick...
PWM inverter harmonics contributions to the inverter-fed induction machine bearing fault diagnosis
Akin, Bilal; Toliyat, Hamid A.; Orguner, Umut; Rayner, Mark (2007-03-01)
The effects of inverter harmonics on motor current fault signatures are studied in detail in this paper. According to theory and experimentation, the fault signatures caused by the inverter harmonics are similar and comparable to those generated by the fundamental harmonic of the line current. Unlike the utility-driven motor, monitoring the current of the inverter-fed motor is considerably noisy, which can mask the fault signatures and render a wrong fault warning. Therefore, the proposed additional fault d...
PB-ISAM : a process-based framework for information systems effectiveness assessment in organizational contexts
Özkan, Sevgi; Bilgen, Semih; Department of Information Systems (2006)
A number of approaches of assessment associated with IS effectiveness have been examined, fundamental guidelines for research in this area have been derived, and a novel model of IS effectiveness has been proposed. A process based assessment method (PB-ISAM) based on the proposed effectiveness model has been elaborated. The new model and the new assessment method have been evaluated via three case studies. Specific implications have been drawn concerning the relationships between processes and the informati...
Pyrolysis characteristics of Turkish lignites in N-2 and CO2 environments
BARZEGAR, RAMİN; Avşaroğlu, Sevil; Yozgatlıgil, Ahmet; Atımtay, Aysel (2018-01-01)
Pyrolysis characteristics and kinetic parameters of two Turkish lignites having different ash contents (Orhaneli as low ash and Soma as high ash sample) were studied under N-2 and CO2 atmospheres by means of thermogravimetric analysis. The isoconversional kinetic methods of FlynnWallOzawa, KissingerAkahiraSunose, and Friedman were employed to estimate the activation energy and pre-exponential factors. The experiments were conducted at four different heating rates of 5, 10, 15, and 20 degrees C/min within th...
Citation Formats
F. A. Yıldırım, “Pb(Zr0.52Ti0.48)O3 films on stainless steel by chemical solution deposition,” Middle East Technical University, 2002.