Implementation of vector control for induction motor drives

Can, Hayrettin


Implementation of IBM binary synchronous communication protocol on burroughs large systems
Önder, Soner; Genç, Payidar; Department of Computer Engineering (1988)
Implementation of a vector controlled induction motor drive
Acar, Akın; Ertan, Hulusi Bülent; Department of Electrical and Electronics Engineering (2004)
High dynamic performance, which is obtained from dc motors, became achievable from induction motors with the recent advances in power semiconductors, digital signal processors and development in control techniques. By using field oriented control, torque and flux of the induction motors can be controlled independently as in dc motors. The control performance of field oriented induction motor drive greatly depends on the correct stator flux estimation. In this thesis voltage model is used for the flux estima...
Implementation of noise filtering algorithm for automated pressure transient analysis
Coşar, Doğuhan; Sınayuç, Çağlar; Department of Petroleum and Natural Gas Engineering (2022-9-2)
In order to estimate reservoir parameters such as permeability and skin factor, well tests are performed. Pressures are recorded periodically during these tests. These parameters are crucial in predicting the amount of oil or gas that can be produced. The analysis of pressure changes provide information about the reservoir characteristics and its ability to produce hydrocarbons at a certain amount of time. Three different cases of drawdown tests are analyzed. Derivative curves are plotted using data poin...
Implementation of mesh generation algorithms
Yıldız, Özgür; Yüksel, Önder; Kuzuoğlu, Mustafa; Department of Electrical and Electronics Engineering (2001)
In this thesis, three mesh generation software packages have been developed and implemented. The first two were based on structured mesh generation algorithms and used to solve structured surface and volume mesh generation problems of three-dimensional domains. Structured mesh generation algorithms were based on the concept of isoparametric coordinates. In structured surface mesh generation software, quadrilateral mesh elements were generated for complex three-dimensional surfaces and these elements w...
Zolfaghari Borra, Mona; Bek, Alpan; Ünalan, Hüsnü Emrah; Department of Micro and Nanotechnology (2021-7-29)
The integration of photonic components with electrical elements on the same silicon chip may lead to the development of new technologies. One limitation is the space available on the wafer surface, which is restricted. Currently, conventional fabrication techniques produce devices only on the top thin layer of the wafer surface. As a result, new architectural designs are required. Producing functional components deep inside Si without creating damage to the surfaces is a potential technique for overcoming t...
Citation Formats
H. Can, “Implementation of vector control for induction motor drives,” Middle East Technical University, 1999.