Experimental investigation of surface finish improvement in face turning

Download
075818.pdf
1998
Çalık, Faruk
Show full item record
53
views
86
downloads
https://hdl.handle.net/11511/1961
Graduate School of Natural and Applied Sciences, Thesis

Suggestions

Experimental Investigation of New Indices of Broken Rotor Bar in Induction Motor
Oumaamar, M. E. K.; Razik, H.; Rezzoug, A.; Chemali, H.; Khezzar, A. (2011-09-10)
Most of rotor related faults in three-phase induction motors are due to broken rotor bars and end-ring defects. Nowadays Inductions motors are more frequently used with inverters which make the diagnosis process more complicated. Furthermore, some manufacturers of induction machines mount converters (i.e. rectifier and inverter) directly onto the machine, which makes the stator current unattainable for diagnosis. In order to overcome these drawbacks, the authors propose to analyze new motor fault signatures...
Experimental Investigation of Eccentric Reinforced Concrete Beam-Column-Slab Connections under Earthquake Loading
Burak Bakır, Burcu (2004-08-01)
The inelastic behavior of beam-to-column joints has been studied since 1960’s; however, there is still limited information on eccentric connections, in which the centerline of the spandrel beam does not coincide with the centroid of the column. In this experimental study, the seismic behavior of three 3/4- scale eccentric beam-column-slab subassemblies was investigated. The main design parameters were selected as the eccentricity, normal beam width, and column section aspect ratio. The eccentricity between ...
Experimental Investigation of Strength of Curved Beam by Thin Ply Non-Crimp Fabric Laminates
Arca, M. A.; PAPİLA, MELİH; Çöker, Demirkan (2016-06-09)
Resistance against delamination failure and through the thickness tensile properties of curved carbon fiber reinforced plastics composites are investigated experimentally by conducting the curved beam strength tests. Effect of novel material thin ply non crimp fabric (NCF) architecture on delamination resistance of carbon fiber reinforced composites are investigated and compare with that of standard UD layups. In order to determine through the thickness tensile properties of curved carbon fiber composites, ...
EXPERIMENTAL INVESTIGATION OF FATIGUE DAMAGE ACCUMULATION IN 1100-AL ALLOY
BILIR, OG (Elsevier BV, 1991-01-01)
The cumulative fatigue damage characteristics of 1100 Al alloy were studied to gain a better understanding of the effects of the loading sequence, the percentage of initial applied load cycles and the stress ratio.
Experimental Investigation of Effusion and Film Cooling for Gas Turbine Combustor
İnanlı, Sinan; Yasa, Tolga; Ulaş, Abdullah (2016-07-12)
Experimental study was conducted to understand the heat transfer characteristics of film or effusion cooled test plates that represent the gas turbine combustor liner. Two effusion cooling test plates having different hole angles (30 and 75° with horizontal) were used. Film cooling tests were conducted by six different slot geometries. Test geometries were the scaled-up model of real combustor liner. Three different blowing ratios were applied for each test plate geometry. Surface cooling effectiveness was ...
Citation Formats
F. Çalık, “Experimental investigation of surface finish improvement in face turning,” Middle East Technical University, 1998.
METU IIS - Integrated Information Service open@metu.edu.tr