Formation and penetration of shaped charge jet

Download
093203.pdf
2000
Özel, Serkan
Show full item record
98
views
0
downloads
https://hdl.handle.net/11511/2897
Graduate School of Natural and Applied Sciences, Thesis

Suggestions

Formation and Characterization of Sub-Micron Inert Particle Embedded Nickel Composite Coatings
Yılmaz Tüzün, Özgül; Karakaya, İshak (2017-06-01)
Composite coatings have a wide range of application areas requiring improved mechanical and tribological properties. Due to its enhanced properties, Ni-Al2O3 electro-co-deposition rather than pure Ni electrodeposition was investigated. A typical sulfamate bath was used to evaluate the effects of current density on hardness and the amount of deposited Al2O3. It was found that increase in current density increases the hardness and deposited wt.% Al2O3 particles within the parameter ranges covered in this stud...
Formation and evolution of breathers in a chain of nonlinear coupled oscillators
Güçlü, Hasan; Bilikmen, Sinan; Department of Physics (2001)
Formation of TiB2 by volume combustion and mechanochemical process
Bilgi, Eda; ÇAMURLU, HASAN ERDEM; Akgun, Baris; Topkaya, Yavuz Ali; SEVİNÇ, NACİ (Elsevier BV, 2008-04-01)
Titanium diboride was produced both by volume combustion synthesis (VCS) and by mechanochemical synthesis (MCP) through the reaction of TiO2, B2O3 and Mg. VCS products, expected to be composed of TiB2 and MgO, were found to contain also side products such as Mg2TiO4, Mg3B2O6, MgB2 and TiN. HCl leaching was applied to the reaction products with the objective of removing MgO and the side products. Formation of TiN could be prevented by conducting the VCS under an argon atmosphere. Mg2TiO4 did not form when 40...
Formation and characterization of infrared absorbing copper oxide surfaces
Arslan, Burcu; Erdogan, Metehan; Karakaya, İshak (2017-04-30)
Copper oxide formation has been investigated to combine the advantages of producing different size and shapes of coatings that possess good light absorbing properties. An aqueous blackening solution was investigated and optimum composition was found as 2.5 M NaOH and 0.225 M NaClO to form velvet copper oxide films. A two-step oxidation mechanism was proposed for the blackening process by carefully examining the experimental results. Formation of Cu2O was observed until the entire copper surface was covered ...
Formation of gold plated electroformed copper structures
Arslan, Burcu; Karakaya, İshak (2016-01-01)
Gold-plated electroformed copper structures are used to protect sensors from stray radiation and improve the image quality in infrared cameras, imaging systems, missile guidance systems and several other devices. These multilayer electroformed objects have tight dimensional and weight tolerances. Furthermore, their internal and external surfaces often exhibit low and high emissivity, respectively. Reflectivity at the outer surface was achieved by gold electrodeposition. Moreover, inner copper layer was conv...
Citation Formats
S. Özel, “Formation and penetration of shaped charge jet,” Middle East Technical University, 2000.
METU IIS - Integrated Information Service open@metu.edu.tr