Determination of the speed of light by a micrawave interferometer.

1969
Özmen, Atilla

Suggestions

Determination of the dispersion of supported Pt particles by gas-phase and liquid-phase measurements
Kivrak, Hilal; Mastalir, Agnes; Kiraly, Zoltan; Üner, Deniz (Elsevier BV, 2009-02-15)
The dispersion of a Pt/gamma-Al2O3 catalyst was investigated by various experimental techniques. The values obtained by gas-phase hydrogen and carbon monoxide adsorption and transmission electron microscopy (TEM) were consistent for the metal:adsorbate stoichiometry of 1:1. However, these methods overestimated the number of active sites available for a liquid-phase reaction. For the hydrogenation of styrene in the presence Of CS2 as a catalyst poison, only the defect sites were found to be active in the cat...
Determination of surface temperature rise on spur gears
Taburdağıtan, Murat; Akkök, Metin; Department of Mechanical Engineering (2001)
Determination of the whiteness appearance of the crystal sugars by visual appearance and reflectance measurements methods.
Çürük, Vehbi; Department of Chemistry (1981)
Measurement of the mass difference between top and antitop quarks
Chatrchyan, S.; et. al. (Springer Science and Business Media LLC, 2012-06-01)
A measurement of the mass difference between the top and the antitop quark (Delta m(t) = m(t) - m((t) over bar)) is performed using events with a muon or an electron and at least four jets in the final state. The analysis is based on data collected by the CMS experiment at the LHC, corresponding to an integrated luminosity of 4.96 +/- 0.11 fb(-1), and yields the value of Delta m(t) = -0.44 +/- 0.46 (stat.) +/- 0.27 (syst.) GeV. This result is consistent with equality of particle and antiparticle masses requ...
Determination of flow through centrifugal pump impellers.
Acarbay, Ayşe; Department of Mechanical Engineering (1969)
Citation Formats
A. Özmen, “Determination of the speed of light by a micrawave interferometer.,” Middle East Technical University, 1969.