Show/Hide Menu
Hide/Show Apps
Logout
Türkçe
Türkçe
Search
Search
Login
Login
OpenMETU
OpenMETU
About
About
Open Science Policy
Open Science Policy
Open Access Guideline
Open Access Guideline
Postgraduate Thesis Guideline
Postgraduate Thesis Guideline
Communities & Collections
Communities & Collections
Help
Help
Frequently Asked Questions
Frequently Asked Questions
Guides
Guides
Thesis submission
Thesis submission
MS without thesis term project submission
MS without thesis term project submission
Publication submission with DOI
Publication submission with DOI
Publication submission
Publication submission
Supporting Information
Supporting Information
General Information
General Information
Copyright, Embargo and License
Copyright, Embargo and License
Contact us
Contact us
Investigation of the electrical parameters of Ag/p-TlGaSeS/C Schottky contacts
Date
2012-07-25
Author
QASRAWI, ATEF FAYEZ HASAN
Hasanlı, Nızamı
Metadata
Show full item record
This work is licensed under a
Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License
.
Item Usage Stats
66
views
0
downloads
Cite This
p-type TlGaSeS single crystal was used to fabricate a Schottky device. Silver and carbon metals were used as the Ohmic and Schottky contacts, respectively. The device which displayed wide RF band at 13.200 and narrow band at 62.517 kHz with Q value of 1.4 and of 6.3 x 10(4), respectively, is characterized by means of current (I)-voltage (V), capacitance (C)-voltage characteristics as well as capacitance-frequency (f) characteristics. The device series resistance, ideality factor and barrier height are determined from the I-Vcurve as 35.8 M Omega, 1.2 and 0.74 eV, respectively. The apparent acceptor density and the build in voltage of the device increased with increasing ac signal frequency. The high Q value, observed at 62.517 kHz. indicated a much lower rate of energy loss relative to the stored energy of the device. The energy loss (Q(-1)) is much less than 0.001% of the stored value. The device was tested and found to remain at the same mode of resonance for several hours. It never switched or ceased unless it was tuned off.
Subject Keywords
Varactor
,
TlGaSeS
,
Diode
,
Barrier height
URI
https://hdl.handle.net/11511/34967
Journal
MATERIALS SCIENCE AND ENGINEERING B-ADVANCED FUNCTIONAL SOLID-STATE MATERIALS
DOI
https://doi.org/10.1016/j.mseb.2012.04.021
Collections
Department of Physics, Article
Suggestions
OpenMETU
Core
Dynamical and passive characteristics of the Ag/TlGaSeS/Ag RF resonators
Qasrawi, A. F.; Elayyat, S. M. S.; Hasanlı, Nızamı (2012-06-01)
Ag contacts on the surface of the TlGaSeS single crystals are observed to exhibit Schottky characteristics. The ideality factor of the Ag/ TlGaSeS/Ag device decreased from 5.2 to 1.3 by the reduction of series resistance effect on the I-V characteristics. Cheung's model analysis revealed a series resistance and barrier height of 40.6 KO and 0.32 V, respectively. The device was run on the passive mode by injection with an alternating ac signal of variable frequency in the frequency range of 0-120 MHz and rec...
Investigation of defect levels in Bi12SiO20 single crystals by thermally stimulated current measurements
Isik, M.; Delice, S.; Hasanlı, Nızamı (2021-12-01)
Bi12SiO20 (BSO) single crystal belongs to the sillenite semiconducting family known as defective compounds. The present paper investigates the defect centers in BSO grown by Czochralski method by means of thermally stimulated current (TSC) measurements performed in the 10-260 K range. The TSC glow curve obtained at heating rate of beta = 0.1 K s(-1) presented several peaks associated with intrinsic defect centers. The activation energies of defect centers were revealed as 0.09, 0.15, 0.18, 0.22, 0.34, 0.70 ...
Investigation of solder materials and bond formation for wafer level packaging of mems devices
Temel, Oğuzhan; Akın, Tayfun; Department of Micro and Nanotechnology (2020-10)
MEMS devices are microscale systems which are fabricated using micro fabrication techniques. MEMS systems suggest many different functional devices for both military applications and consumer products. The packaging of MEMS devices is one of the most challenging parts of MEMS commercialization. Each type of MEMS device may need special operation environment. Therefore, the packaging of MEMS devices must provide required hermeticity in order to keep the special environment throughout the device's lifetime. A...
Investigation of Defects in CZT Single Crystals
Yaşar, Bengisu; Kabukçuoğlu, Merve; Ergunt, Yasin; Parlak, Mehmet; Turan, Raşit; Kalay, Yunus Eren (2017-03-02)
The II-IV compound semiconductor CZT single crystal is a highly prominent material for the fabrication of various industrial applications such as gamma ray/X-ray detectors, electro-optic modulators and solar cells. Often, CZT single crystals suffer from various crystallographic defects emerged during crystal growth and post-growth cooling processes. In the scope of this research, the nano scale defects were investigated by using HRTEM. Single crystalline CZT crystals were grown using a three-zone vertical B...
Simultaneous determination of bismuth and tellurium using tungsten coil atom trap with inductively coupled plasma mass spectrometry /
Bora, Selin; Ataman, Osman Yavuz; Department of Chemistry (2016)
Atom traps such as slotted quartz tube, quartz plate and tungsten coil have been used in atomic spectrometry in order to preconcentrate analyte hydrides and then detection was done by atomic absorption or fluorescence spectrometry. In this study, tungsten coil atom trap was used for the first time with plasma spectrometry. A novel method, which is called Hydride Generation Tungsten Trap Inductively Coupled Plasma Mass Spectrometry (HG-W-Trap-ICPMS), was developed in the first part of this study. Then as a s...
Citation Formats
IEEE
ACM
APA
CHICAGO
MLA
BibTeX
A. F. H. QASRAWI and N. Hasanlı, “Investigation of the electrical parameters of Ag/p-TlGaSeS/C Schottky contacts,”
MATERIALS SCIENCE AND ENGINEERING B-ADVANCED FUNCTIONAL SOLID-STATE MATERIALS
, pp. 981–985, 2012, Accessed: 00, 2020. [Online]. Available: https://hdl.handle.net/11511/34967.