Vibrational Spectra of Spinel—Type Compound CuIn5S8

1992-01-01
Hasanlı, Nızamı
Gasanova, L.G.
Magomedov, A.Z.
Show full item record
Creative Commons License
This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.
52
views
0
downloads
Lattice-Vibrations
https://hdl.handle.net/11511/39280
physica status solidi (b)
Department of Physics, Article

Suggestions

Robustness Analysis of Intentional Mistuning Patterns in Randomly Mistuned Bladed Disk Assemblies
Yumer, M. E.; Ciğeroğlu, Ender; Özgüven, Hasan Nevzat (2010-09-22)
It is known that bladed disks, which are usually designed as cyclically symmetric structures, undergo considerable amount of forced response amplitude magnification due to the phenomenon called mistuning. Mistuning is inevitable for any cyclically symmetric bladed disk assembly since it is caused by manufacturing tolerances, material properties and operational wear. Since reducing the level of mistuning beyond certain limits is not possible with the current technology, the attempts are rather made to reduce...
Filtration testing of a ceramic capillary filter produced from a high-silica glaze
San, O; Hoşten, Çetin (2002-07-01)
A laboratory procedure for the production of a ceramic capillary filter from a high-silica glaze was described and its filtration response was tested in dead-end and periodic vacuum filtration modes with suspensions containing micron and sub-micron clay particles obtained from a ceramic factory wastewater stream. The same glaze raw material ground to two different levels of fineness was used for the production of the porous ceramic substrate and its surface coating. The coating particulate sol was deposited...
Vibration isolation of inertial measurement unit
Çınarel, Dilara; Ciğeroğlu, Ender; Department of Mechanical Engineering (2012)
Sensitive devices are affected by extreme vibration excitations during operation so require isolation from high levels of vibration excitations. When these excitation characteristics of the devices are well known, the vibration isolation can be achieved accurately. However, it is possible to have expected profile information of the excitations with respect to frequency. Therefore, it is practical and useful to implement this information in the design process for vibration isolation. In this thesis, passive ...
Influence of the temperature dependence of the yield stress on the stress distribution in a heat-generating tube with free ends
Orcan, Y; Gulgec, M (2000-08-01)
Based on Tresca's yield condition and its associated flow rule, the elastic-plastic deformation of a heat-generating tube with free ends is investigated by taking into consideration the influence of the temperature dependence of the yield stress. It is found that the expansion of the inner plastic zones as well as the stress state are affected markedly owing to the reduction in the yield stress at elevated temperatures, The stress distribution and the expansion of different plastic regions are displayed gra...
Organizational memory in construction companies : a case based reasoning model as an organizational learning tool
Özorhon, Beliz; Dikmen Toker, İrem; Department of Civil Engineering (2004)
Companies struggle against complex and dynamic conditions in order to survive in their business settings. Being in the knowledge era, learning has been accepted as one of the main sources of sustainable competitive advantage. Organizational learning (OL) is a set of activities to obtain organizational memory (OM) by acquiring, sharing, interpreting, integrating and institutionalizing knowledge. OM is exploited by the companies in strategic decision-making process, which makes OL a critical concept. The majo...
Citation Formats
N. Hasanlı, L. G. Gasanova, and A. Z. Magomedov, “Vibrational Spectra of Spinel—Type Compound CuIn5S8,” physica status solidi (b), pp. 0–0, 1992, Accessed: 00, 2020. [Online]. Available: https://hdl.handle.net/11511/39280.
METU IIS - Integrated Information Service open@metu.edu.tr