Show/Hide Menu
Hide/Show Apps
Logout
Türkçe
Türkçe
Search
Search
Login
Login
OpenMETU
OpenMETU
About
About
Open Science Policy
Open Science Policy
Open Access Guideline
Open Access Guideline
Postgraduate Thesis Guideline
Postgraduate Thesis Guideline
Communities & Collections
Communities & Collections
Help
Help
Frequently Asked Questions
Frequently Asked Questions
Guides
Guides
Thesis submission
Thesis submission
MS without thesis term project submission
MS without thesis term project submission
Publication submission with DOI
Publication submission with DOI
Publication submission
Publication submission
Supporting Information
Supporting Information
General Information
General Information
Copyright, Embargo and License
Copyright, Embargo and License
Contact us
Contact us
Effects of 2,4-dichlorophenol on activated sludge
Date
2002-07-01
Author
ŞAHİNKAYA, ERKAN
Dilek, Filiz Bengü
Metadata
Show full item record
This work is licensed under a
Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License
.
Item Usage Stats
94
views
0
downloads
Cite This
The effects of 2,4-dichlorophenol (2,4-DCP) on both acclimated and unacclimated activated sludge were investigated in batch reactors. The IC50 values on the basis of maximum specific growth rate (mu(m)), percent chemical oxygen demand (COD) removal efficiency and sludge activity were found to be 72, 60 and 47 mg l(-1), respectively, for unacclimated culture. The percent COD removal efficiencies of unacclimated culture were affected adversely, even at low concentrations, whereas culture acclimated to 75 mg 2,4-DCP l(-1) could tolerate about 200 mg 2,4-DCP l(-1) on the basis of COD removal efficiency. Although yield coefficient values of unacclimated culture increased surprisingly to very high values with the addition of 2,4-DCP, a linear decrease with respect to 2,4-DCP concentrations was observed for acclimated culture. Although no removal was observed with unacclimated culture, almost complete removal of 2,4-DCP up to a concentration of 148.7 mg l(-1) was observed with acclimated culture. It was showed that the culture could use 2,4-DCP as sole organic carbon source, although higher removal efficiencies in the presence of a readily degradable substrate were observed. Culture acclimated to 4-chlorophenol used 2,4-DCP as sole organic carbon source better than those acclimated to 2,4-DCP.
Subject Keywords
Fluidized-Bed Treatment
,
Chlorophenol Degradation
,
Aerobic Treatment
,
Waste-Water
,
Removal
,
Respirometer
,
Constituents
,
Chemicals
,
Phenols
,
Toxicity
URI
https://hdl.handle.net/11511/42380
Journal
APPLIED MICROBIOLOGY AND BIOTECHNOLOGY
DOI
https://doi.org/10.1007/s00253-002-0989-5
Collections
Department of Environmental Engineering, Article
Suggestions
OpenMETU
Core
Effect of biogenic substrate concentration on 4-chlorophenol degradation kinetics in sequencing batch reactors with instantaneous feed
ŞAHİNKAYA, Erkan; Dilek, Filiz Bengü (Elsevier BV, 2006-09-01)
Two sequencing batch reactors (SBRs) instantaneously fed with 200mg/l 4-chlorophenol (4-CP) were operated at different feed peptone concentrations to investigate the effect of biogenic substrate (peptone) concentrations on reactor performance, yield coefficient (Y) and 4-CP degradation kinetics. One of the reactors was operated at 10 days of sludge retention time (SRT) and the other was operated at 20 days of SRT. High chemical oxygen demand (COD) removal efficiencies (90-95%) and complete 4-CP removals (de...
Effect of feeding time on the performance of a sequencing batch reactor treating a mixture of 4-CP and 2,4-DCP
ŞAHİNKAYA, Erkan; Dilek, Filiz Bengü (Elsevier BV, 2007-06-01)
This paper investigated the biodegradation kinetics of 4-chlorophenol (4-CP) and 2,4-dichlorophenol (2,4-DCP) separately in batch reactors and mixed in sequencing batch reactors (SBRs). Batch reactor experiments showed that both 4-CP and 2,4-DCP began to inhibit their own degradation at 53 and 25 mgl(-1), respectively, and that the Haldane equation gave a good fit to the experimental data because r(2) values were higher than 0.98. The maximum specific degradation rates (q(m)) were 130.3 and 112.4 mg g(-1) h...
Effects of operational parameters and ultrasonic pretreatment on supercritical CO2 extraction of diesel fuel from soil
Guvenc, A; Mehmetoglu, U; Mehmetoglu, T (Informa UK Limited, 2004-01-01)
Supercritical fluid extraction (SFE) using CO2 was performed on soil material artificially contaminated with diesel fuel. Raising the temperature from 313 K to 343 K caused the recovery efficiency to increase from 52 to 76%. Pressure and CO2 flow rate were found to be less important. As expected, increasing extraction time resulted in higher recoveries. Ultrasonic pretreatment of the soil material was found to be very effective, possibly due to disrupting the strong interaction bonding between soil matrix a...
Effects of nickel, chromium and initial feed concentration on the batch growth of a microbial consortium developed from sewage
Gökçay, CELAL FERDİ; Dilek, Filiz Bengü (Informa UK Limited, 1991-01-01)
Effects of nickel, chromium and substrate concentration on the microbial growth of acclimatized and unacclimatized microbes of sewage origin were studied in batch cultures at a constant temperature of 25 °C, at pH 7.0. A synthetic medium supplemented with Ni(II) (5 and 10 mgl‐1) or Cr(VI) (1 and 50 mgl‐1) or with their combinations and at various feed concentrations (650, 975, 1300 mgl‐1) was employed to investigate the effects on the specific growth rate (μm) of the microbial culture. The experimental resu...
Effect of heating rate on thermal properties and kinetics of raw and cleaned coal samples
Özbas, Kazim Esber; Hicyilmaz, Cahit; Kök, Mustafa Verşan (Informa UK Limited, 2003-01-01)
In this article, thermogravimetry (TG/DTG) was used to determine the effect of heating rate on the thermal properties and kinetics of raw and cleaned coal samples from Soma, Tuncbilek, and Afsin Elbistan regions. TG/DTG experiments were carried out at 4 different heating rates (5, 10, 15, and 20degreesC/min). Generally, for all of the samples higher peak and burnout temperatures were measured with an increasing heating rate. Kinetic parameters of the samples were determined using an Arrhenius-type kinetic m...
Citation Formats
IEEE
ACM
APA
CHICAGO
MLA
BibTeX
E. ŞAHİNKAYA and F. B. Dilek, “Effects of 2,4-dichlorophenol on activated sludge,”
APPLIED MICROBIOLOGY AND BIOTECHNOLOGY
, pp. 361–367, 2002, Accessed: 00, 2020. [Online]. Available: https://hdl.handle.net/11511/42380.