Flexural cracking in underreinforced beams.

1978
Guven, I Metin
Show full item record
65
views
0
downloads
https://hdl.handle.net/11511/4930
Graduate School of Natural and Applied Sciences, Thesis

Suggestions

Flexural strengthening and repair of RC slabs by adding a new RC layer
AYKAÇ, SABAHATTİN; KALKAN, İLKER; Tankut, Ali Tuğrul (Wiley, 2016-12-01)
The present paper summarizes the findings of an experimental programme to investigate a strengthening/repair technique through the introduction of a new RC layer to an existing slab. Six RC slabs, composed of twelve cantilever and six interior spans, were tested under monotonic transverse loading. The behaviour of statically determinate cantilever spans and indeterminate interior spans was examined by comparing the test results of these specimens to the results of reference slabs, in which the existing and ...
Flexural behavior of lightly and heavily reinforced steel fiber concrete beams
Mertol, Halit Cenan; Baran, Eray; Bello, Hussain Jibril (2015-11-15)
Flexural behavior of lightly and heavily reinforced steel fiber concrete beams was investigated. The test series consisted of 20 singly reinforced beams having 180 x 250 x 3500 mm dimensions. The main parameters in the testing program were the type of concrete and the amount of longitudinal reinforcement. Ten different longitudinal reinforcement ratios (with a minimum of 0.2% and a maximum of 2.5%) covering the range from under-reinforced to over-reinforced beam behavior were used in the testing program. Tw...
Flexural cracking in partially prestresses concrete beams.
Keyder, Engin; Ersoy, Uğur; Department of Civil Engineering (1972)
Flexural Strength Design Criteria for Concrete Beams Reinforced with High-Strength Steel Strands
Baran, Eray (2012-10-01)
This paper summarizes the result of a study investigating the flexural behavior of concrete beams reinforced with high-strength prestressing strands. Thirteen concrete beams reinforced with either conventional reinforcing bars or high-strength strands were fabricated and load tested in the experimental part of the study. No distinct difference was detected between the experimentally obtained cracking patterns of the two groups of beams. For the same reinforcement amount, beams reinforced with high-strength ...
Flexural and bonding properties of a denture base polymer treated with nitric acid or ultraviolet radiation before relining with Molloplast-b
Dogan, Orhan Murat; Keskin, Selda; Bolayir, Giray; Usanmaz, Ali; Bek, Buelent (Informa UK Limited, 2007-01-01)
This study investigated adhesive forces and flexural strength of acrylic resin denture base relined with Molloplast-B soft lining material. To increase bonding between the two materials, the surface of the resin was modified with ultraviolet (UV) irradiation or nitric acid treatment. The peel strength greatly increased with nitric acid treatment because of the high polarity on the poly (methyl methacrylate) (PMMA) surface and the increase in the surface roughness, whereas low peel strength was seen with the...
Citation Formats
I. M. Guven, “Flexural cracking in underreinforced beams.,” Middle East Technical University, 1978.
METU IIS - Integrated Information Service open@metu.edu.tr