Development of a method to improve the limiting drawing ratio of blanks using preferential heating of the flange region.

1989
Aydoğan Saraç, Mine

Suggestions

DEVELOPMENT OF AN INTERFEROMETRIC TECHNIQUE TO BE USED IN MEASURING MICRON LEVEL CLEARANCES FILLED WITH A LUBRICANT
Yildirim, Murat; Dursunkaya, Zafer; Okutucu Özyurt, Hanife Tuba (2009-10-21)
The aim of this study is to develop an interferometric technique to measure micron level clearances occurring in small piston-cylinder arrangements; such as hermetically sealed compressors. A Cartesian model of the piston cylinder arrangement is manufactured and lateral and vertical motions are generated via a step motor, and micrometers, respectively, to simulate the piston motion and the change of clearance during the motion. Experiments are conducted in air and a lubricant. Measurements show the importan...
Development of an elasto-plastic analytical model for design of grouted rock bolts in tunnels with particular reference to poor rock masses
Osgoui, Reza Rangsaz; Karpuz, Celal; Department of Mining Engineering (2007)
The analysis presented in this thesis provides a methodology for grouted bolts design, based on empirical and analytical methods. Hence, the main objectives of this thesis are to offer practical means for better characterisation of poor to very poor rock masses, to better predict support pressure, and to develop an elasto-plastic analytical model for design of grouted bolts in tunnels excavated in such rock masses. To improve the applicability of the GSI (Geological Strength Index) in poor to very poor rock...
Development of a screening model for the cyclic steam injection (CSI) process
Yalgın, Gamze; Kök, Mustafa Verşan; Artun, Emre; Department of Petroleum and Natural Gas Engineering (2017)
Cyclic steam injection (CSI), a single-well enhanced oil recovery method for heavy oil reservoirs, is characterized with three stages: injection, soaking, and production which altogether constitute a cycle. In this study, it is aimed to develop a screening model that can be used to accept or reject a given CSI proposal from a representative performance indicator. This indicator is estimated from a large set of reservoir & CSI design characteristics, using the screening model developed. The model has been tr...
DEVELOPMENT OF A HAND METHOD TO ESTIMATE FUNDAMENTAL PERIODS OF STEEL ECCENTRICALLY BRACED FRAMES
Kusyilmaz, Ahmet; Topkaya, Cem (2016-12-09)
This paper describes formulation of a hand method which can be used to estimate the computed fundamental periods of vibration of steel eccentrically braced frames (EBFs). The developed method uses the Rayleigh's method as a basis and utilizes the roof drift ratio under seismic forces as a parameter. The roof drift ratio was obtained from EBF designs by considering different seismic hazard, number of stories, braced bay width, and link length to bay width ratio. A simple expression was developed to represent...
Development of a new testing procedure to measure thermal fatigue performance of asphalt concrete
Shabani, Reza; Güler, Murat; Department of Civil Engineering (2020-11)
In the scope of this study, a new test procedure is developed to investigate the thermal fatigue performance of asphalt concrete materials. To achieve this, test samples are compacted using different mixtures to be designed according to the Superpave mix design method. In the testing program, compacted samples are cut to produce beam specimens for thermal coefficient tests and semicircular specimens for thermal fatigue tests. Analysis of variance (ANOVA) and Multivariate analyses are both used to evaluate t...
Citation Formats
M. Aydoğan Saraç, “Development of a method to improve the limiting drawing ratio of blanks using preferential heating of the flange region.,” Middle East Technical University, 1989.