A feasibility study on the implementation of computer aided statistical process control (SPC) for mechanical parts

Download
015534.pdf
1991
Ergül, Murat Ünal
Show full item record
56
views
0
downloads
https://hdl.handle.net/11511/6377
Graduate School of Natural and Applied Sciences, Thesis

Suggestions

A preliminary study on the use of reservoir simulation and coal mine ventilation methane measurements in determining coal reservoir properties
Erdoğan, Sinem Setenay; Okandan, Ender; Kracan, Cevat Özgen; Department of Petroleum and Natural Gas Engineering (2011)
This thesis investigates methane emissions and methane production potentials from abandoned longwall panels produced or emitted due to mining activities either from coal seam or any underlying or overlying formations. These emissions can increase greenhouse gas concentrations and also pose a danger to the underground working environment and to miners. In addition to the safety issues, recovery and utilization of this gas is an additional source of energy. In this study, methane concentrations measured from ...
A Preliminary study on construction of a high capacity tensiometer and its use in measurement of matrik suction in unsaturated soils
Köksalan, Ali Okan; Toker, Nabi Kartal; Department of Civil Engineering (2013)
Soil suction is one of the main state parameters that governs unsaturated soil behaviour. Tensiometers are the only type of probe that can measure soil suction directly, but only up to 90 kPa. In the past two decades, a new type of tensiometer with much greater measurement range (up to 2 MPa) has appeared in the literature. The measurement range (i.e. capacity) of a tensiometer is limited by (i) how well it is saturated, and (ii) the air entry value of its porous interface. In this study, the first high cap...
A study for the development of seismic design specifications for coastal structures
Gözpınar, Erdem; Yalçıner, Ahmet Cevdet; Ergin, Ayşe; Department of Civil Engineering (2003)
An evolving design philosophy for port structures in many seismically active regions reflects the observations that: -The deformations in ground and foundation soils and the corresponding structural deformation and stress states are key design parameters. -Conventional limit equilibrium-based methods are not well suited to evaluating these parameters. -Some residual deformation may be acceptable. Performance-based design is an emerging methodology whose goal is to overcome the limitations present in convent...
A technical feasibility study on the use of Çavundur geothermal field for greenhouse heating
Kasapoğlu, Hüseyin; Parlaktuna, Mahmut; Department of Petroleum and Natural Gas Engineering (2003)
Protective cultivation is widely used nowadays in order to increase crop yield by creating the optimum conditions such as temperature, humidity and CO2 content, irrespective of outside conditions. Since plant production doubles for every 10 degrees increase in temperature to a certain limit, this makes temperature a very important factor for optimum plant growth. In order to keep the greenhouse temperature constant during changes in outside conditions, heating and often cooling are required. Heating of a gr...
A feasibility study on bridge scour countermeasures
Özdemir, C. Emre; Yanmaz, Ali Melih; Department of Civil Engineering (2003)
Citation Formats
M. Ü. Ergül, “A feasibility study on the implementation of computer aided statistical process control (SPC) for mechanical parts,” Middle East Technical University, 1991.
METU IIS - Integrated Information Service open@metu.edu.tr