A development system with in-circuit emulation capability.e stations.

1980
Akar, Ahmet Armağan
Show full item record
62
views
0
downloads
https://hdl.handle.net/11511/6518
Graduate School of Natural and Applied Sciences, Thesis

Suggestions

A BMS development project with an integrated inspection program
Akgül, Ferhat (2012-07-12)
A bridge management system is being developed together with an integrated inspection program. A pilot bridge group consisting of 200 bridges is selected for inspections which are located along the state and provincial roads in Turkey. In addition to visual inspections of the pilot bridges, detailed inspections for 10 deteriorated bridges will also be performed. Detailed inspections will be performed using non-destructive testing equipments. Visual inspections for the pilot bridge group have already been com...
A GIS-based Management System for Underground Mining Safety
Demirel, Nuray (Lambert Academic Publishing, 2010-01-01)
Mine safety is of paramount concern to the mining industry. In this sense the generation of a Geographic Information Systems (GIS) which can administrate relevant spatial data efficiently is a very vital issue for underground mining safety. In an effort to achieve a balance of safety and productivity, GIS can contribute to the creation of a safe working environment in underground (U/G) mining. Such a system should serve to a continuous risk analysis and be designed for applications in case of emergency. The...
A small wind energy conservation system for autonomous applications.
Esh-Shair, Wlliam N; Department of Electrical Engineering (1984)
A passive cooling system proposal for multifunction and high power displays
Tarı, İlker (2013-02-07)
Flat panel displays are conventionally cooled by internal natural convection, which constrains the possible rate of heat transfer from the panel. On one hand, during the last few years, the power consumption and the related cooling requirement for 1080p displays have decreased mostly due to energy savings by the switch to LED backlighting and more efficient electronics. However, on the other hand, the required cooling rate recently started to increase with new directions in the industry such as 3D displays,...
A Software tool for vehicle calibration, diagnosis and test via controller area network
Civelek, Utku; Schmidt, Şenan Ece; Department of Electrical and Electronics Engineering (2012)
Controller Area Networks (CAN’s) in vehicles need highly sophisticated software tools to be designed and tested in development and production phases. These tools consume a lot of computer resources and usually have complex user interfaces. Therefore, they are not feasible for vehicle service stations where low-performance computers are used and the workers not very familiar with software are employed. In this thesis, we develop a measurement, calibration, test and diagnosis program -diaCAN- that is suitable...
Citation Formats
A. A. Akar, “A development system with in-circuit emulation capability.e stations.,” Middle East Technical University, 1980.
METU IIS - Integrated Information Service open@metu.edu.tr