An exeperimental behaviour of asphaltic mixtures under creep loading reference to a specific mix composition.

Download
1988
Al-Dulemi, Abid Mohammed

Suggestions

An analysis of tunnel fire characteristics under the effects of vehicular blockage and tunnel inclination
SHAFEE, SINA; Yozgatlıgil, Ahmet (Elsevier BV, 2018-09-01)
It is known that the blockage and inclination conditions of tunnels are among the important factors affecting fire safety considerations, as these factors could change the characteristics of possible fire incidents as well as smoke movement in tunnels. In the present work, we analyze the variations of the tunnel fire burning rate, heat release rate and smoke backlayering as being functions of these two factors. Ethanol pools were used as fire sources in a reduced scale tunnel model with longitudinal ventila...
AN ESTIMATION OF THE MAXIMUM INTERSTORY DRIFT RATIO FOR SHEAR-WALL TYPE STRUCTURES
Koleva, G.; Sandu, I.; Akkar, S. (2008-05-20)
In displacement-based engineering, the maximum interstory drift ratio (MIDR) is one of the most influential parameters for evaluating the seismic performance of existing structural systems. MIDR is also a key parameter in force-based designs satisfying serviceability lit-nits for new structural systems. A set of predictive equations is derived for estimating MIDR on shear-wall systems with fundamental periods ranging from 0.5 to 1.25 s. The equations are derived from a recently compiled ground-motion datase...
A HEAT-TRANSFER CORRELATION FOR LIQUID-SOLID FLOWS IN HORIZONTAL PIPES
OZBELGE, TA; SOMER, TG (Elsevier BV, 1994-08-01)
Heat transfer from a solid surface to a fluid-solid suspension in vertical or horizontal transport is of importance in the design of heat-exchangers, driers, fluidized beds, and slurry pipeline reactors. There are fewer studies on heat transfer in liquid-solid flows than on gas-solid flows. In this paper, a correlation for heat transfer to dilute liquid-solid flows in a horizontal pipe is presented. Suspension properties were used to derive the following equation: Nu(s) = 0.202Res0.6Prs0.675(D/d(p))0.092(mu...
An investigation of variation of state of residual stress in the thickness direction in butt welded plates.
Berme, Necip; Department of Mechanical Engineering (1965)
An analytical assessment of elastic and inelastic response spectra
Dicleli, Murat; Sucuoğlu, Haluk (1994-05-01)
Citation Formats
A. M. Al-Dulemi, “An exeperimental behaviour of asphaltic mixtures under creep loading reference to a specific mix composition.,” Middle East Technical University, 1988.