The effect of surface roughness of the rake face of the cutting forces and machinability of steel

1974
Akhtar, Ali
Show full item record
36
views
0
downloads
https://hdl.handle.net/11511/6791
Graduate School of Natural and Applied Sciences, Thesis

Suggestions

The Effect of retained austenite and carbide distribution on the wear resistance of bearing steel
Özgeneci, Zeren; Ögel, Bilgehan; Department of Metallurgical and Materials Engineering (2017)
This study aims to investigate the effect of the amount of retained austenite and undissolved carbides on the wear resistance of the heat treated bearing steels. As inner and outer ring material 100Cr6 steel grade was used. The specimens were austenitized in the range 800°C to 1000°C, and then, quenched to room temperature in oil to produce a hard martensitic phase. A composite microstructure of undissolved carbides, martensite and retained austenite were observed in hardened steel specimens. It was seen th...
The effect of Cu and austempering treatment parameters on the impact toughness and hardness of ductile cast iron
Yaşar, Hakan; Tekin, Erdoğan; Department of Metallurgical Engineering (1994)
THE EFFECT OF CLEANING MEDIUM VELOCITY AND TEMPERATURE ON THE CORROSION OF STEEL
UNSAL, A; Selçuk, Nevin; DORUK, M (1988-02-01)
The effect of time on the form and stability of Pickering Emulsions
Ayrancı Tansık, İnci (2013-08-18)
The permeability of asphaltic concrete mixtures under pressure and the effect of filler/bitumen ratio on permeability
Okuyucu, Hakan; Yüce, Rüştü; Department of Civil Engineering (1996)
Citation Formats
A. Akhtar, “The effect of surface roughness of the rake face of the cutting forces and machinability of steel,” Middle East Technical University, 1974.
METU IIS - Integrated Information Service open@metu.edu.tr