Analysis and experimentation on a heat pipe .

1974
Erkan, Uğur
Show full item record
44
views
0
downloads
https://hdl.handle.net/11511/7074
Graduate School of Natural and Applied Sciences, Thesis

Suggestions

Analysis and verification of a pyroshock test system
Küçükbayram, Anıl İsmail; Özer, Mehmet Bülent; Department of Mechanical Engineering (2021-2-03)
In the aerospace industry, systems, subsystems, and units are exposed toexplosive events during their lifecycle. Any explosive event creates shock in the structure, and it propagates until it is damped. This shock wave may be hazardous for some electronic and optical components. It may damage a component and cause failure in the equipment. For this reason, satellite equipmenthas tobe qualifiedto withstand all static and dynamic loads encountered during launch and operational life. Thus, one of ...
Analysis and design of a low flow rate regulator.
Bayrakçı, Sami; Department of Mechanical Engineering (1978)
Analysis and design of a circularly polarized microstrip antenna
Taştan, Mehmet; Koç, Seyit Sencer; Department of Electrical and Electronics Engineering (2006)
In this study we tried to design a microstrip antenna, to get a suitable radiation pattern for a LEO satellite. Our aim is to get a radiation pattern that has a maximum power which is not in the broadside direction to the antenna surface; instead broadside radiation has a relatively lower power density. Maximum power radiation is desired to be at about 30 50 degrees angle beyond the normal to the antenna surface. We desire circularly polarized radiation. We used two concentric antennas; one is a circular p...
Analysis and design of induction heating work coils
El-Fatallah, Ali; Ermiş, Muammer; Department of Electrical and Electronics Engineering (1988)
Analysis and design of a compliant variable stroke mechanism
TANIK, ENGİN; Söylemez, Eres (Elsevier BV, 2010-10-01)
In this paper, analysis and design of an underactuated compliant variable stroke mechanism are presented by employing its pseudo-rigid-body model (PRBM). During the design two cases are considered: prescribed output loading and constant input torque. It is shown that this mechanism is suitable where variable stroke is required corresponding to variable output loading. It is also observed that this mechanism is capable of providing nearly constant force over a wide range of input. The analysis and design app...
Citation Formats
U. Erkan, “Analysis and experimentation on a heat pipe .,” Middle East Technical University, 1974.
METU IIS - Integrated Information Service open@metu.edu.tr