Batmamış Sazlıkların Dalga Geçişine Etkisinin Deneysel Araştırılması

Oğuz, Elif
Akgul, M Adil


A new route to synthesis of nanocomosites by using an unsaturated polyester matrix
Toprak, Pelin; Yılmazer, Ülkü; Department of Chemical Engineering (2004)
This study was conducted to investigate the effects of organoclay type and concentration on the nanocomposites synthesized by أIn-Situ Polymerizationؤ and أPrepolymerizationؤ methods. In-Situ Polymerization Method was in fact a new route which consisted of dispersing the monomers; propylene glycol, maleic anhydride and o-phthalic anhydride into the galleries of montmorillonite followed by subsequent polymerization. The Prepolymerization Method involved the addition of montmorillonite to the previously synth...
Kaymalı yatakların sayısal analizi ve piston-silindir yatağının deneysel inceleme yöntemi geliştirilmesi
Yıldırım, Murat; Okutucu Özyurt, Hanife Tuba; Kerpiçci, Hüsnü; Dursunkaya, Zafer(2009-09-01)
Batalle de Sarikamiş
Turan, Ömer (Universidad Nacional Costa Rica, 2015-01-01)
Investigation of the effect of hydrated lime on low temperature cracking of asphalt concrete
Varlı Bingöl, Başa; Güler, Murat.; Department of Civil Engineering (2019)
The main objective of this study is to investigate the effect of hydrated lime on low-temperature cracking resistance of hot mix asphalt (HMA) mixtures. To this end, a comprehensive laboratory experimental program is established to evaluate the influence of hydrated lime modification, aggregate type, aggregate gradation and asphalt binder aging on temperature-related failure of HMA specimens. These specimens prepared from materials obtained from Turkish General Directorate of Highways are fabricated followi...
Numerical investigation of solidification
Alrmah, Masoud; Dursunkaya, Zafer; Department of Mechanical Engineering (2005)
Finite element solution of solidification process in 2-D Cartesian and axisymmetric geometries is investigated. The use of finite element may result in spurious increase of temperature in the field and the selection of the mushy zone range when used as a numerical tool along with the selection of the mesh size results in large errors in the predicted solidification time. The approach works best for problems where the mushy zone range is finite and the thermal conductivities of both phases are high.
Citation Formats
E. Oğuz and M. A. Akgul, “Batmamış Sazlıkların Dalga Geçişine Etkisinin Deneysel Araştırılması,” 2012, vol. 2, Accessed: 00, 2021. [Online]. Available: