Examination of thermal properties and failures of brick walls by the use of infrared thermograpy and hot box method

Date

2013-09-16

Author

Koçkar, Rukiye
Tavukçuoğlu, Ayşe
Arslan, Metin

Metadata

Show full item record

Item Usage Stats

33
views

0
downloads

URI

https://hdl.handle.net/11511/75409

Collections

Unverified, Conference / Seminar

Suggestions

OpenMETU
Core

Examination of methane hydrate formation by the use of dual impeller combinations Longinos, Sotirios Nik.; Parlaktuna, Mahmut (2021-01-01) The kinetics of methane gas hydrates formation was obtained by different dual impeller (DI) experiments with full baffle (FB) at 42.5 bar pressure and 2 °C temperature. There were 18 (dual and dual mixed) experiments by the use of pitched blade turbine upward trending (PBTU), pitched blade turbine downward trending (PBTD), rushton turbine (RT) and new impeller design trapezoid turbine in upward trending and down ward trending, TTU and TTD respectively. There were estimations of induction time, duration of h...
Investigation of Moisture Dissipation in Foam-Based Warm Mix Asphalt Using Synchrotron-Based X-Ray Microtomography Kutay, M. Emin; Öztürk, Hande Işık (American Society of Civil Engineers (ASCE), 2012-06-04) Foam-based Warm Mix Asphalt (WMA) technologies decrease the viscosity of the asphalt so that it is workable during construction. However, after construction, viscosity increases rapidly as the foam disappears and temperature drops. During the process of dissipation of foam, depending on the environmental conditions, the moisture may not escape and may be trapped inside the mixture. This trapped moisture can cause detrimental failures by breaking the adhesive bonds between the aggregates and the asphalt bind...
Investigation of mechanical property changes after MIG welding of (7XXX) series aluminum alloys Okay, Sena; Ögel, Bilgehan; Batıgün, Caner; Department of Metallurgical and Materials Engineering (2016) There is an increasing demand for aluminum alloys not only in aerospace industry but also in automotive industry due to its low density. Welding is the most effective and commonly used joining technique in those industries, therefore, aluminum welding plays an important role. 7039 aluminum alloy, is a high strength alloy and it is suitable for armor applications. Like other aluminum alloys, after MIG welding, remarkable decrease in strength is observed and therefore applications are restricted. The aim of t...
Examination of two types of dental bridge models by photoelasticity technique and experimental determination of chewing forces by strain gauge measurements. Akkoyunlu, Selim Erol; Department of Mechanical Engineering (1975)
Investigation of productivity of heavy oil carbonate reservoirs and oil shales using electrical heating methods Hasçakır, Berna; Akın, Serhat; Department of Petroleum and Natural Gas Engineering (2008) The recovery characteristics of Bolu-Himmetoglu, Bolu-Hatıldag, Kütahya- Seyitömer, and Nigde-Ulukısla oil shale samples and Batı Raman, Çamurlu, and Garzan crude oil samples were tested experimentally using retort and microwave heating techniques. Many parameters like heating time, porosity, water saturation were studied. To enhance the efficiency of the processes three different iron powders (i.e.; Fe, Fe2O3, and FeCl3) were added to the samples and the doses of the iron powders were optimized. While crud...

Citation Formats

R. Koçkar, A. Tavukçuoğlu, and M. Arslan, “Examination of thermal properties and failures of brick walls by the use of infrared thermograpy and hot box method,” 2013, Accessed: 00, 2021. [Online]. Available: https://hdl.handle.net/11511/75409.