The effect of higher harmonic control on the vibratory loads and airframe vibration reduction of a light helicopter

Date

2013-09-03

Author

Aykut, Tamer
Va, Muscarello
Pa, Masaratı
Ga, Quaranta
Yaman, Yavuz

Metadata

Show full item record

Item Usage Stats

114
views

0
downloads

URI

https://hdl.handle.net/11511/77479

Conference Name

ERF2013, 39th European Rotorcraft Forum, (03 - 06 Eylül 2013)

Collections

Unverified, Conference / Seminar

Suggestions

OpenMETU
Core

The effect of double austenitization on the microstructure and toughness of AISI M2 high speed steel Ögel, Bilgehan (1998-06-01) In this study, the effect of double austenitization on microstructure and toughness of AISI M2 high speed steel was investigated. For double austenitization treatment, the specimens, which are hardened initially at 1220 degrees C and quenched in air, were hardened for a second time in the temperature range 1150 - 1050 degrees C. For comparison purposes, another set of specimens is austenitized singly in the temperature range 1150 - 1050 degrees C. Tempering process was carried out between 500 - 640 degrees ...
The effect of austempering on microstructure and impact toughness of DIN 34CrNiMo5 gun barrel steel Kurtuluş, B. Murat; Tekin, Erdoğan; Department of Metallurgical Engineering (1994)
The Effect of retained austenite and carbide distribution on the wear resistance of bearing steel Özgeneci, Zeren; Ögel, Bilgehan; Department of Metallurgical and Materials Engineering (2017) This study aims to investigate the effect of the amount of retained austenite and undissolved carbides on the wear resistance of the heat treated bearing steels. As inner and outer ring material 100Cr6 steel grade was used. The specimens were austenitized in the range 800°C to 1000°C, and then, quenched to room temperature in oil to produce a hard martensitic phase. A composite microstructure of undissolved carbides, martensite and retained austenite were observed in hardened steel specimens. It was seen th...
The effect of hot-deformation on mechanical properties and age hardening characteristics of Al-Mg-Si based wought aluminum alloys Tan, Evren; Ögel, Bilgehan; Department of Metallurgical and Materials Engineering (2006) Microstructural and mechanical characterizations of heat treatable Al-Mg-Si-Cu based wrought aluminum alloys have been studied. The aim of this work was to produce fine grained, high strength alloy by adjusting processing conditions: deformation, solutionizing and aging. First, primary characterization was carried out via SEM-EDS analyses and tensile tests. Then an extensive experimental study has been carried out on two sets of samples. The first set has been studied to determine the ideal conditions for s...
The effect of double austenitization on microstructure and fracture toughness of AISI M2 high speed steel Ögel, Bilgehan; Tekin, Erdoğan; Department of Metallurgical Engineering (1990)

Citation Formats

T. Aykut, M. Va, M. Pa, Q. Ga, and Y. Yaman, “The effect of higher harmonic control on the vibratory loads and airframe vibration reduction of a light helicopter,” presented at the ERF2013, 39th European Rotorcraft Forum, (03 - 06 Eylül 2013), Moskova, Rusya, 2013, Accessed: 00, 2021. [Online]. Available: https://hdl.handle.net/11511/77479.