Performance of a spark ignition engine fueled with ethanol water blends at high compression rations.

1981
Tanribilir, Arif Hakan

Suggestions

Performance of a multicylinder passenger car engine fueled with ethanol and gasoline.
Uşşaklı, Tuğrul; Department of Mechanical Engineering (1980)
Performance of a flat grooved heat pipe with a localized heat load
Sezmen, Ramazan Aykut; Çetin, Barbaros ; Dursunkaya, Zafer (2021-05-18)
Heat pipes are phase change heat transfer devices used in wide range of heat transport applications due to their high thermal transport capacities with low temperature differences. Heat pipes are especially preferred for electronic cooling applications and aerospace avionics to satisfy high heat transfer rate requirements. In this study, heat transfer and phase change mechanisms of working fluid are investigated and modeled using a 3-D thermal resistance network for multichannel flat grooved heat pipes. Fir...
Performance of a distillation column packed with circular discs. /
Özbelge, H. Önder; Department of Chemical Engineering (1969)
Performance of an alkaline fuel cell with single or double layer electrodes
Han, E; Eroğlu, İnci; Turker, L (2000-02-01)
In the present research, the improvement of an alkaline fuel cell performance by changing the electrode structure and manufacturing method has been achieved by employing multilayer, Teflon-bonded gas diffusion type electrodes which were prepared by the rolling method. Active carbon or carbon black was used as the support material, platinum as the catalyst and nickel screen as the backing material. Double layer electrodes possessed the active and the diffusion layers on the backing layer. However, the single...
Performance of a Pumped Discharge Line with Combined Application of Protection Devices Against Water Hammer
REZAEİ, Vahid; Çalamak, Melih; Bozkuş, Zafer (2017-05-01)
This study investigates the performance of a pumped discharge line with joint use of protective devices against water hammer expected to occur due to sudden stoppage of pumps. To this end, a pumped discharge line planned to be constructed is considered for hydraulic transients generated subsequent to pump trips. The unprotected form of the system is found to experience very low pressures below the vapor pressure of the liquid. Then single and combined application of flywheel, air chamber and in-line check v...
Citation Formats
A. H. Tanribilir, “Performance of a spark ignition engine fueled with ethanol water blends at high compression rations.,” Middle East Technical University, 1981.