Investigation on pulse trains in electric discharge machining (E.D.M).

1982
Çoğun, Can
Show full item record
59
views
0
downloads
https://hdl.handle.net/11511/7794
Graduate School of Natural and Applied Sciences, Thesis

Suggestions

Investigation on the use of water as dielectric liquid in electric discharge machininig.
Temel, Dilek; Department of Mechanical Engineering (1977)
Investigation of battery chargers for telecommunication equipment and design of an automatic gain control unit
Şen, Mehmet; Ermiş, Muammer; Department of Electrical and Electronics Engineering (1989)
Investigation of bit hydraulics for gasified drilling fluids
Doğan, Hüseyin Ali; Özbayoğlu, Mehmet Evren; Department of Petroleum and Natural Gas Engineering (2004)
Accurate determination of the pressure losses at the bit is very important for drilling practices in petroleum industry. In the literature, there are several studies on determination of the pressure losses. Major focus is concentrated on single phase drilling fluids, which is far from accurate estimation of pressure losses for multiphase fluids, i.e., fluids including a liquid and a gas phase, at the bit. Some of these models are valid for multiphase fluids, however, they are either valid for very high gas ...
Investigation on replication of microfluidic channels by hot embossing
Yıldırım, Ender; Arıkan, Mehmet Ali Sahir (2017-01-01)
In this study, effects of embossing temperature, time, and force on production of a microfluidic device were investigated. Polymethyl methacrylate (PMMA) substrates were hot embossed by using a micromilled aluminum mold. The process parameters were altered to observe the variation of replication rate in width and depth as well as symmetry of the replicated microfluidic channels. Analysis of variance (ANOVA) on the experimental results indicated that embossing temperature was the most important process param...
Investigations on bulk glass forming ability of titanium based multicomponent alloys
Süer, Sıla; Mekhrabov, Amdulla O.; Department of Metallurgical and Materials Engineering (2008)
The aim of this study is to investigate the bulk glass forming ability (BGFA) of Ti-based alloy systems. These investigations were carried out in two main parts that are complementary to each other: theoretical and experimental. For theoretical studies, which are based on electronic theory of alloys in pseudopotential approximation, Ti-Zr, Ti-Co and Ti-Cu alloys were chosen as the binary systems. Alloying element additions were performed to each binary for the investigation of the BGFA of multicomponent Ti-...
Citation Formats
C. Çoğun, “Investigation on pulse trains in electric discharge machining (E.D.M).,” Middle East Technical University, 1982.
METU IIS - Integrated Information Service open@metu.edu.tr