Stress Distribution Based Partitioning of Helmets for 3 D Printing



Stress behavioursof viscoelastic flowaround square cylinder
Tezel Tanrısever, Güler Bengüsu; Yapıcı, Kerim; Uludağ, Yusuf (2019-06-01)
In this study, it is aimed the numerically investigation of the flow of liner PTT (Phan-Thien-Tanner) fluid, which is a viscoelastic fluid model over limited square obstacle by finite volume method. The finite volume method has been used for simultaneous solution of continuity, momentum and fluid model equations with appropriate boundary conditions. The effects of the inertia in terms of Reynolds number, Re, (0 < Re < 20) and the of elasticity in terms of Weissenberg number, We, (1 < We < 15) of PTT flow ...
Stress and deformation distribution in a dragline bucket using finite element analysis
Gölbaşı, Onur; Demirel, Nuray (null; 2011-10-21)
Weight control parameter studies in polymer compounding extruders
İbili, Oktay; Kısakürek, Bilgin; Department of Chemical Engineering (1999)
Stress resultants plasticity with general closest point projection
Sarıtaş, Afşin (Elsevier BV, 2011-03-01)
In this paper, general closest point projection algorithm is derived for the elastoplastic behavior of a cross-section of a beam finite element. For given section deformations, the section forces (stress resultants) and the section tangent stiffness matrix are obtained as the response for the cross-section. Backward Euler time integration rule is used for the solution of the nonlinear evolution equations. The solution yields the general closest projection algorithm for stress resultants plasticity model. Al...
Force and flowfield measurements of a bio-inspired flapping MAV ‘Delfly Micro’
Deng, Shuanghou; Perçin, Mustafa; van Oudheusden, Bas W.; Remes, Bart; Tenaglia, Andrea (2014-06-18)
Citation Formats
G. Başara, İ. Tarı, and Z. S. Tarı, “Stress Distribution Based Partitioning of Helmets for 3 D Printing,” 2016, Accessed: 00, 2021. [Online]. Available: