Radiation induced solid-state post polymerization of acenaphthylene.

Date

1984

Author

Ülkem, İlhan

Metadata

Show full item record

Item Usage Stats

47
views

0
downloads

URI

https://hdl.handle.net/11511/8324

Collections

Graduate School of Natural and Applied Sciences, Thesis

Suggestions

OpenMETU
Core

Radiation-induced and electro-initiated polymerization of some epoxy monomers. Önal, Ahmet M; Usanmaz, Ali; Department of Chemistry (1983)
Radiation induced solid-state polymerization of acetylenedicarboxylic acid Usanmaz, Ali; Alturk, E (2002-01-01) Radiation induced solid-state polymerization of acetylenedicarboxylic acid was carried out at room temperature in open atmosphere and under vacuum conditions. The gray colored powder polymer obtained was insoluble in most common solvents but only partially soluble in DMSO and THF. The limiting conversion to polymer was about 5%. The polymer was characterized by IR, UV, DP-MS, DSC, TGA, and XRD. The mechanism of polymerization was elucidated from the available data. Polymerization followed a free radical mec...
Radiation effect on polyadenylic acid in aqueous solution Testereci, H. Nur; Usanmaz, Ali; Department of Chemistry (1993)
Radiation-Induced Solid-State Polymerization of Allylthiourea and Crystal Structure Effects Usanmaz, Ali; Yılmaz, Elvan (Informa UK Limited, 1987-5) Allylthiourea crystals grown from water and from ethanol have been found to belong to the space groupP21/c and P21/m or related, respectively. The corresponding unit cell parameters are a = 13.45 Å, b = 17.33 Å,c = 14.38 Å, β = 96.6°, and d = 1.18g/cm3 for water-grown crystals, and a = 14.65 Å, b = 17.18 Å, c = 13.15 Å, β = 95.5°, and 1.17 g/cm3 for ethanol-grown crystals.
Radiation grafting of various water-soluble monomers on ultra-high molecular weight polyethylene powder: Part I. Grafting conditions and grafting yield Aydinli, B; Tincer, T (Elsevier BV, 2001-02-01) Monomers of some water-soluble polymers; acrylic acid, methacrylic acid, acrylamide, N, N-dimethyl acrylamide and 1-vinyl-2 pyrrolidone, were grafted on ultra-high molecular weight polyethylene (UHMWPE) powders by a direct grafting method in an aqueous medium in air. Inhibition of homopolymerisation was achieved by adding various concentrations of Fe2+ or Cu2+ ions. It was found that the degree of grafting increases linearly with dose till a gelation state is reached, and varies between 40 and 12% depending...

Citation Formats

İ. Ülkem, “Radiation induced solid-state post polymerization of acenaphthylene.,” Middle East Technical University, 1984.