Determination of mechanical properties of peritoneum on a microprocessor controlled setup designed for this purpose

Download
1988
Çelikbilek, Sinan

Suggestions

Determination of ion dose and profiles in Ge-74 and Sn-120 implanted silicon layers by PIXE, NAA, RBS and SIMS
Belin, B; Bode, P; Turan, Raşit; Van Meerten, TG (2004-01-01)
Implanted Ge-74 and Sn-121 concentrations in silicon (Si) layers were investigated by particle induced X-ray emission (PIXE), instrumental neutron activation analysis (INAA), Rutherford backscattering spectrometry (RBS) and secondary ion mass spectrometry (SIMS). Slight differences were observed in the results obtained. It was shown that PIXE and INAA are as powerful as the traditional RBS and SIMS spectroscopy for the investigation of thin layered Si.
Determination of Internal Stress of Ni Electroplated Samples in Sulphamate Solutions
Aykac, B.; Erdogan, M.; Karakaya, İshak (2017-06-01)
Internal stress is a common problem affecting the functionality of the electroplated materials. The parameters of electrodeposition and additive materials that are soluble in the bath change the characteristics of the plating and affect the internal stress of the coatings. The influence of the electrodeposition parameters on the internal stress of Ni deposits from the nickel sulphamate baths were studied by the help of fractional factorial design. The parameters included temperature, pH, current density and...
Determination of the influence of TiO2 on the elastic properties of a mica based glass ceramic by ultrasonic velocity measurements
Gür, Cemil Hakan; Öztürk, Abdullah (Elsevier BV, 2005-11-15)
The influence of small amount (1 or 2 wt%) of TiO2 additions and crystallization heat treatment on the elastic properties of a mica based glass ceramic have been investigated by ultrasonic velocity measurements. The mica based glass ceramic was prepared through controlled crystallization of a glass in the SiO2, Al2O3, CaO, MgO, K2O and F system. Evidences of TiO2 acting as a nucleating agent in this system was demonstrated. The longitudinal and transversal wave velocities of the as-prepared glass and the mi...
Determination of microstructural properties of pm Al-Sic composities by ultrasonic techniques
Ataş, Esra; Gür, C. Hakan; Ögel, Bilgehan; Department of Metallurgical and Materials Engineering (2000)
Determination of relations between elastic properties of cement mortars by using destructive and nondestructive methods
Deniz, Saygın; Erdoğan, Sinan Turhan; Department of Civil Engineering (2010)
The measurement and monitoring of the elastic properties of cement-based materials is very important for assessing their quality, integrity and performance. Due to the nonhomogeneous and time-dependent characteristics of these materials, it is difficult to observe the developments in elastic properties with traditional destructive methods. The aim of this thesis is to determine and monitor elastic properties of mortar specimens made with different cements by using resonant frequency and ultrasonic pulse vel...
Citation Formats
S. Çelikbilek, “Determination of mechanical properties of peritoneum on a microprocessor controlled setup designed for this purpose,” Middle East Technical University, 1988.