A large signal technique for designing voltage controlled transistor oscillators with optimum power output

Download

015553.pdf

Date

1991

Author

Kara, Muharrem

Metadata

Show full item record

Item Usage Stats

51
views

0
downloads

URI

https://hdl.handle.net/11511/8545

Collections

Graduate School of Natural and Applied Sciences, Thesis

Suggestions

OpenMETU
Core

A Novel Noise Reduction Technology for Switched Reluctance Motors Bizkevelci, Erdal; Özlü Ertan, Hatice Gülçin; Leblebicioğlu, Mehmet Kemal (2008-07-24) The conditions are sought at which an SIR motor can be operated with highest efficiency, while producing a desired torque output at low shaft torque ripple. The investigation is based on the simulation software that uses measured flux-linkage (V, 0, 1) and static torque (T, 0, 1) characteristics of a given motor. The variation of the shaft torque, torque ripple and efficiency of the motor Is investigated, while the control variables "advance angle" and "conduction angle" are swept over their range with a co...
A novel method for the vibration reduction of an air vehicle missile launcher Aksoy, T.; Acar, B.; Özgen, Gökhan Osman (2019-01-01)
A Spectral Solenoidal-Galerkin Method for Rotating Thermal Convection between Rigid Plates Yıldırım, Cihan; Yarımpabuç, Durmuş; Tarman, Hakan I. (Hindawi Limited, 2013) The problem of thermal convection between rotating rigid plates under the influence of gravity is treated numerically. The approach uses solenoidal basis functions and their duals which are divergence free. The representation in terms of the solenoidal bases provides ease in the implementation by a reduction in the number of dependent variables and equations. A Galerkin procedure onto the dual solenoidal bases is utilized in order to reduce the governing system of partial differential equations to a system ...
A novel method to measure the glass and melting transitions of pharmaceutical powders Abiad, Mohamad G.; Gonzalez, David C.; Mert, Behiç; Campanella, Osvaldo H.; Carvajal, M. Teresa (Elsevier BV, 2010-08-30) A method to measure thermo-mechanical properties of pharmaceutical and polymeric powders was developed The measurements are conducted by characterizing the material's response to applied acoustic waves Measurements were performed using griseofulvin, felodipine and indomethacin as model drugs and polyethylene oxide (MW 200,000, 900,000, 2,000,000 Da) as model polymers. The method employed measures the mechanical Impedance enabled the calculation of the powder theological and thermo-mechanical properties. Mea...
A Coordinate transformation technique for two dimensional solidification problems with a circular phase change interface Odabaşı, Gülnihal; Dursunkaya, Zafer; Department of Mechanical Engineering (1997)

Citation Formats

M. Kara, “A large signal technique for designing voltage controlled transistor oscillators with optimum power output,” Middle East Technical University, 1991.