CFD Analysis of A Wind Turbine Airfoil at High Reynolds Numbers

2021-07-14
Aslan, Ezgi
Orbay Akcengiz, Ezgi
Sezer Uzol, Nilay
Show full item record
Creative Commons License
This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.
149
views
133
downloads
https://hdl.handle.net/11511/97120
https://su2foundation.org/su2conference2021/
2nd SU2 Conference, Virtual Event, 12-14 July 2021
Center for Wind Energy (RÜZGEM), Conference / Seminar

Suggestions

CFD simulation of the developing boundary layer in an atmospheric wind tunnel
Kıran, Defne; Aksel, Mehmet Haluk; Çete, Ali Ruhşen; Department of Mechanical Engineering (2018)
Structural coupling methods are widely used in predicting dynamics of coupled systems. In this study, the reverse problem, i.e. predicting the dynamic behavior of a particular subsystem from the knowledge of the dynamics of the overall system and of all the other subsystems, is studied. This problem arises when a substructure cannot be measured separately, but only when coupled to neighboring substructures. The dynamic decoupling problem of coupled linear structures is well investigated in literature. Howev...
CFD analysis of helicopter rotors in forward flight
Ali Oğuz, Yüksel; Özyörük, Yusuf (null; 2017-09-20)
CFD-DEM Simulation of a Conical Spouted Bed Operating with High Density Particles
Golshan, Shahab; Zarghami, Reza; Mostoufi, Navid; KÖKSAL, MURAT; Külah, Görkem (2016-08-04)
The hydrodynamics of a spouted bed operating with high density zirconia particles was studied by CFD-DEM simulations. The model was validated by experimental data. Simulation results were used to obtain radial and axial profiles of the particle velocity, solid hold-up and flux in the bed at two bed heights. The gas jet velocity profile in the spout was also studied. For calculation of the solid circulation time in the bed, axial positions of 50 particles were traced in time. The mean solids circulation time...
CFD analyses of heat sinks for CPU cooling
Öztürk, Emre; Tarı, İlker; Department of Mechanical Engineering (2004)
In this study, forced cooling of heat sinks mounted on CPU̕s was investigated. Heat sink effectiveness, effect of turbulence models, effect of radiation heat transfer and different heat sink geometries were numerically analyzed by commercially available computational fluid dynamics softwares Icepak and Fluent. The numerical results were compared with the experimental data and they were in good agreement. Conjugate heat transfer is simulated for all the electronic cards and packages by solving Navier-Stokes ...
CFD Analyses of a Notebook Computer Thermal Management System and a Proposed Passive Cooling Alternative
Tarı, İlker (2010-06-01)
A notebook computer thermal management system is analyzed using a commercial computational fluid dynamics software package (ANSYS Fluent). The active and passive paths that are used for heat dissipation are examined for different steady state operating conditions. For each case, average and hot-spot temperatures of the components are compared with the maximum allowable operating temperatures. It is observed that when low heat dissipation components are put on the same passive path, the increased heat load o...
Citation Formats
E. Aslan, E. Orbay Akcengiz, and N. Sezer Uzol, “CFD Analysis of A Wind Turbine Airfoil at High Reynolds Numbers,” presented at the 2nd SU2 Conference, Virtual Event, 12-14 July 2021, Amerika Birleşik Devletleri, 2021, Accessed: 00, 2022. [Online]. Available: https://hdl.handle.net/11511/97120.
METU IIS - Integrated Information Service open@metu.edu.tr