Perturbation parameters associated with nonlinear responses of the head at small amplitudes

2005-06-01
Gürses, Senih
Dhaher, Y
Hain, TC
Keshner, EA
The head-neck system has multiple degrees of freedom in both its control and response characteristics, but is often modeled as a single joint mechanical system. In this study, we have attempted to quantify the perturbation parameters that would elicit nonlinear responses in a single degree-of-freedom neuromechanical system at small amplitudes and velocities of perturbation. Twelve healthy young adults seated on a linear sled randomly received anterior-posterior sinusoidal translations with +/- 15 mm and +/- 25 mm peak displacements at 0.81, 1.76, and 2.25 Hz. Head angular velocity and angular position data were examined using a nonlinear phase-plane analysis. Poincare sections of the phase plane were computed and Lyapunov exponents calculated to measure divergence (chaotic behavior) or convergence (stable behavior) of system dynamics. Variability of head angular position and velocity across the entire phase plot was compared to that of the Poincare sections to quantify spatial-temporal irregularity. Multiple equilibrium points and positive Lyapunov exponents revealed chaotic behavior at 0.81 Hz at both amplitudes whereas responses at 1.76 and 2.25 Hz exhibited periodic oscillations, clustered phase points, and negative Lyapunov exponents. However, intersubject variability increased at the lowest frequency and a few subjects presented chaotic behavior at all frequencies. An inverted pendulum with position and velocity threshold nonlinearity was adopted as a simplistic model of the head and neck. Simulations with the model resulted in features similar to those observed in the experimental data. Our principal finding was that increasing the perturbation amplitude had a stabilizing effect on the behavior across frequencies. Nonlinear behaviors observed at the lowest stimulus frequency might be attributed to fluctuations in control between the multiple sensory inputs. Although this study has not conclusively pointed toward any single mechanism as responsible for the responses observed, it has revealed clear directions for further investigation. To examine if changing the sensory modalities would elicit a significant change in the nonlinear behaviors observed here, further experiments that target a patient population with some sort of sensory deficit are warranted. (C) 2005 American Institute of Physics.

Suggestions

Inertial parameter design of spatial mechanisms
Can, Fatih Cemal; Soylu, Reşit; Department of Mechanical Engineering (2003)
In this thesis, the inertial parameters of a spatial mechanism are used in order to optimize various aspects of the dynamic behaviour of the mechanism (such as minimizing actuator torque/ force fluctuations, shaking force/moment balancing, etc.) while the effects of loads are considered as well. Here, inertial parameters refer to the mass, 6 elements of the inertia tensor and coordinates of the center of mass of the links. The concept of Force Fluctuation Number (FFN) is utilized to optimize the dynamic beh...
Iterative receptance method for determining harmonic response of structures with symmetrical non-linearities
BUDAK, E; Özgüven, Hasan Nevzat (1993-01-01)
Although there are several techniques available for the harmonic vibration analysis of non-linear systems, the application of these methods to multi-degree of freedom systems is rather limited. In this study a new method (the Iterative Receptance Method—IRM) is developed for the harmonic vibration analysis of non-linear multi-degree of freedom systems with non-linear stiffness and damping forces. Different kinds of non-linearities are covered by expressing non-linear spring and damping forces as polynomials...
Singularity robust inverse dynamics of planar 2-RPR parallel manipulators
Ider, SK (SAGE Publications, 2004-07-01)
In planar parallel robots, limitations occur in the functional workspace because of interference of the legs with each other and because of drive singularities where the actuators lose control of the moving platform and the actuator forces grow without bounds. A 2-RPR (revolute, prismatic, revolute joints) planar parallel manipulator with two legs that minimizes the interference of the mechanical components is considered. Avoidance of the drive singularities is in general not desirable since it reduces the ...
Nonlinear vibration isolation of inertial measurement unit
Dönmez, Ata; Ciğeroğlu, Ender; Özgen, Gökhan Osman; Department of Mechanical Engineering (2018)
In engineering systems, dynamic parameters of systems such as acceleration, velocity, etc. are measured instantaneously to provide feedback for control systems. Since measurement equipment is sensitive to vibratory environment, performance of them is directly related to how effectively vibration is isolated. Linear vibration isolation systems have limitations due to static deflections and damping characteristic. Therefore, nonlinear elements can be used to improve isolation performance.In this thesis, first...
Modeling and control of constrained flexible joint parallel manipulators
Oğan, Osman Can; İder, Kemal; Department of Mechanical Engineering (2010)
The purpose of the thesis is to achieve a hybrid force and motion control method of parallel manipulators working in a constrained environment, in the presence of joint flexibility that occurs at the actuated joints. A flexible joint is modeled and the equations of motion of the parallel manipulator are derived by using the Lagrange formulation. The structural damping of the active joints, viscous friction at the passive joints and the rotor damping are also considered in the model. It is shown that in a fl...
Citation Formats
S. Gürses, Y. Dhaher, T. Hain, and E. Keshner, “Perturbation parameters associated with nonlinear responses of the head at small amplitudes,” CHAOS, vol. 15, no. 2, pp. 0–0, 2005, Accessed: 00, 2023. [Online]. Available: https://hdl.handle.net/11511/102422.