Modeling and computational experiment on gain characteristics of CO2 lasers.

Download
023482.pdf
1992
Kalay, Yaşar
Show full item record
38
views
0
downloads
https://hdl.handle.net/11511/11815
Graduate School of Natural and Applied Sciences, Thesis

Suggestions

Modeling and experimental evaluation of a rotary peristaltic magnetorheological fluid device with low off-state torque for haptic interfaces
Topcu, Okan; TAŞCIOĞLU, YİĞİT; Konukseven, Erhan İlhan (2018-01-01)
This article presents a novel rotary magnetorheological fluid device with inherently low off-state torque. The working principle of the device is similar to peristaltic pumps except the fluid remains inside the device and circulates continuously. Unlike other continuous rotation magnetorheological fluid devices, which operate in shear mode, the proposed device works in pressure driven flow mode. A proof of concept prototype with arbitrary dimensions is built and experimentally evaluated. Measured off-state ...
Modeling and design of reactor for hydrogen production using non-stoichiometric oxides
Yılmaz, Arda; Kıncal, Serkan; Department of Chemical Engineering (2017)
Nowadays countries investigate to improve alternative energy technologies such as solar power, biomass, wind energy, hydrogen etc. Hydrogen gas is very useful energy carrier and fuel cells produce electricity through hydrogen gas. Hydrogen production technologies are also investigated by many researches due to its high cost production. Thermochemical production way is one of the hydrogen production methods. Solar energy is also clean, renewable and alternative energy source. It is used for heating reaction ...
Modeling and experimental evaluation of variable speed pump and valve controlled hydraulic servo drives
Çalışkan, Hakan; Balkan, Raif Tuna; Department of Mechanical Engineering (2009)
In this thesis study, a valveless hydraulic servo system controlled by two pumps is investigated and its performance characteristics are compared with a conventional valve controlled system both experimentally and analytically. The two control techniques are applied on the position control of a single rod linear actuator. In the valve controlled system, the flow rate through the actuator is regulated with a servovalve; whereas in the pump controlled system, two variable speed pumps driven by servomotors reg...
Modeling and Experimental Study of Newtonian Fluid Flow in Annulus
SORGUN, Mehmet; Ozbayoglu, M. Evren; Aydın, İsmail (2010-09-01)
A major concern in drilling operations is the proper determination of frictional pressure loss in order to select a mud pump and avoid any serious problems. In this study, a mechanistic model is proposed for predicting the frictional pressure losses of light drilling fluid, which can be used for concentric annuli. The experimental data that were available in the literature and conducted at the Middle East Technical University-Petroleum Engineering (METU-PETE) flow loop as well as computational fluid dynamic...
Modeling and experimental identification of quadrotor aerodynamics
Kaya, D. Derya; Kutay, Ali Türker; Department of Aerospace Engineering (2014)
The aim of this study is to obtain mathematical models for aerodynamic forces and moments of rotors of a quadrotor helicopter, and estimate their parameters through wind tunnel tests for hover, vertical climb, and forward flight conditions. The main factors which determine the movement of a quadrotor UAV are the aerodynamic forces and moments in three axes created by four rotors of the vehicle. Hence, accurate calculation of rotor forces and moments in varying flight conditions are essential to establish a ...
Citation Formats
Y. Kalay, “Modeling and computational experiment on gain characteristics of CO2 lasers.,” Middle East Technical University, 1992.
METU IIS - Integrated Information Service open@metu.edu.tr