Wear performance of squeeze cast A356/SiC particulate reinforced composites

Download
075913.pdf
1998
Tarkan, Burak
Show full item record
192
views
0
downloads
https://hdl.handle.net/11511/1669
Graduate School of Natural and Applied Sciences, Thesis

Suggestions

Wear behavior of H10A AISI/SAE steel nitrided by various methods
Yurtışık, Koray; Sarıoğlu, Filiz; Ankara, Alpay; Department of Metallurgical and Materials Engineering (2002)
Wear performance of salt-bath, vacuum, ion nitrided and duplex treated (nitrided and ceramic coated by physical vapor deposition technique) steel dies (H10A AISI/SAE) were studied. The dies were used for forging of steel pastes (52100 AISI/SAE) at 1050°C under 700 MPa for 0.3 - 0.4 seconds during production of bearing rings. The nitrided and un-nitrided dies were investigated via optical and scanning electron microscopy, x-ray diffraction and micro-hardness determination procedures. The service lives of die...
Wear behaviour of a nitrocarburized low-alloy steel
Özyazgan, Tülin; Sarıtaş, Süleyman; Department of Mechanical Engineering (1984)
Wear characteristics of bronze filled ptfe materials when used under slideway conditions.
Akgül, Halil; Department of Mechanical Engineering (1980)
Fatigue performance of PVA fibre reinforced cementitious composite overlays
Aleessa Alam, Burhan; Yaman, İsmail Özgür (2019-07-31)
Pavement maintenance and rehabilitation is as much important as the construction work itself. In this scope, applying the correct and efficient repair method is highly critical for economic and technical reasons. Depending on the damage level, many alternative repair methods exist. Using an overlay is one common method, where a new layer can be directly applied over or replace the top part of an existing pavement. This overlay can be made from asphalt or concrete as well. With the advances in the concrete t...
Wearable supercapacitors based on nickel tungstate decorated commercial cotton fabrics
Hekmat, Farzaneh; Tutel, Yusuf; Ünalan, Hüsnü Emrah (2020-07-01)
Symmetric supercapacitors (SSCs) with remarkable energy storing capability, high specific power as well as long-term cyclic stability were fabricated from nickel tungstate (NiWO4) @ nickel oxide (NiOx) decorated commercial cotton fabrics (CCFs). A commercial cotton-based textile was first made conductive by the state of the art ultrasonic spray coating method. This was followed by chemical and electrochemical processes to decorate activated CCFs with NiO(x)and NiWO4, respectively. The assembled SSCs had the...
Citation Formats
B. Tarkan, “Wear performance of squeeze cast A356/SiC particulate reinforced composites,” Middle East Technical University, 1998.
METU IIS - Integrated Information Service open@metu.edu.tr