Effects of delay period and maximum temperature period on compressive strength of steam cured concrete

Download
093358.pdf
2000
Erdem, Tahir Kemal
Show full item record
63
views
0
downloads
https://hdl.handle.net/11511/2850
Graduate School of Natural and Applied Sciences, Thesis

Suggestions

Effects of Fines Content and Plasticity on Index Properties and Hydraulic Conductivity of Coarse-Fine Mixtures
Ekici, Anıl; Huvaj Sarıhan, Nejan; Akgüner, Cem (2022-02-01)
Ten coarse-fine mixtures (CFM) (intermediate soils) having fines contents (FC) of 0%, 12%, 20%, 30%, 40%, and plasticity indices (PI) of 5% and 15% were prepared in the laboratory by mixing different fractions of gravel, sand, nonplastic silt, kaolin, and bentonite. Index properties, volume change during saturation, specific surface area (SSA), and saturated hydraulic conductivity of CFM were investigated. For compacted CFM, aFC=15%" role="presentation" style="box-sizing: border-box; display: inline; font-s...
Effects of mean flow and temperature on acoustic liner performance in dual stream flow ducts
Özyörük, Yusuf (2009-12-01)
This paper investigates effects of mean flow and temperature on acoustic liner performance in dual stream flow ducts using solutions from a linearized Euler solver, which are verified with and an approximate eigenmode/mode matching technique. A simple, uniform, long cowl duct configuration with partial liner treatment on the outer wall exposed to the cold stream is studied in the present investigation. While the linearized Euler solver uses a Reynolds-Averaged Navier-Stokes solution as the mean flow, the ei...
EFFECTS of ROTATION of MATERIAL AXES ON FREE FLEXURAL VIBRATIONS of CENTRALLY BONDED SYMMETRIC DOUBLE DOUBLER JOINT in COMPOSITE MINDLIN PLATES or PANELS
Yuceoglu, U.; Guvendik, O. (2011-11-17)
The present study investigates the serious effects of rotation of material axes on the free dynamic response of composite plates or panels with "Bonded Double Doubler Mint Systems". The "Plate Adherends" and the "Upper and Lower Doubler Plates" are connected through the relatively very thin adhesive layers. The "Bonded Double Doubler Joint System" is considered in taans of the "System. 1" and the "System.2". In the "System. 1", the material directions of "Plate Adherends" are rotated 90(0) (about z-axis) wh...
Effects of particle density and gas inlet diameter on particle velocity, solids hold-up and flux distributions in conical spouted beds with high density particles
Golshan, Shahab; Yeniceri, Ali; Zarghami, Reza; Mostoufi, Navid; Köksal, Murat; Külah, Görkem (null; 2017-10-01)
Effects of specimen height and loading span on the fracture toughness of disc type rock specimens under three point bending
Tez, Yaşar Burkay; Tutluoğlu, Levent; Department of Mining Engineering (2008)
A relatively new fracture toughness testing method called Straight Notched Disc Bending (SNDB) was used before for fracture testing of Ankara Andesite and Afyon Marble cores. In this work to investigate the applicability of the new method to other rock types. With a preliminary notch of 10 mm, straight notched disc type specimens with a diameter of 75 mm were loaded by three-point bending loads. Investigation of effect of specimen height on the stress intensity factor and fracture toughness was carried out....
Citation Formats
T. K. Erdem, “Effects of delay period and maximum temperature period on compressive strength of steam cured concrete,” Middle East Technical University, 2000.
METU IIS - Integrated Information Service open@metu.edu.tr