Experimental investigation of three rotating parachutes

2006-09-01
Yagiz, Ozgur Evren
Albayrak, Kahraman
Yidirim, R. Orhan

Suggestions

Experimental investigation of a spherical solar collector
Bakır, Öztekin; Yamalı, Cemil; Department of Mechanical Engineering (2006)
The purpose of this study is to investigate the performance of a spherical solar collector by using numerical and experimental methods. For this analysis, equations were obtained by choosing appropriate control volumes in the system and applying The First Law of Thermodynamics. The experiments were realized at four different mass flow rates and non-flow situation. For the numerical simulation of the system, a computer program in Mathcad was written. Another computer program in Mathcad was written for the va...
Experimental investigation of pressurized concrete tunnel linings
Kalaycıoğlu, Münci Tunç; Canbay, Erdem; Department of Civil Engineering (2019)
Behaviour of pressurized tunnels are determined by the mechanical and geometrical properties of lining, mechanical properties and overburden pressure, and the quality of contact zone between rock and lining. These factors form the backbone of the designprocessoftunnelswithinternalpressure. Estimatingcrackwidthsanddamage patternsischallengingdueto thenonlinearinteractionofnaturalandartificiallayers. Inthisstudy,influenceofkeyparametersandFRP-fabric-wraprepairingmethodwere experimentally investigated. Eight spe...
EXPERIMENTAL INVESTIGATION OF HEAT TRANSFER AND PRESSURE DROP OVER RECTANGULAR PROFILE FINS PLACED IN A SQUARE CHANNEL
Aylı, Ece; Kıyıcı, Fırat; Bayer, Özgür; ARADAĞ ÇELEBİOĞLU, SELİN (2014-06-19)
In this study, with the help of a fan, fully developed turbulent flow conditions are experimentally obtained to investigate the heat transfer and pressure drop characteristics of rectangular fins. Fins with different geometries are placed to the bottom surface of a square shaped channel. Finned test pieces are heated by constant heat flux and other parts are kept as well insulated. The effect of fin height to the heat transfer coefficient is investigated by performing experiments. Temperature distributions,...
Experimental investigation of shaft transducerless speed and position control of ac induction and interior permanent magnet motors
Goksu, Omer; Hava, Ahmet Masum (2010-01-01)
In order to drive AC motors with high efficiency and high motion performance, and to provide accurate speed/position control, motor shaft speed and/or position feedback is required. For this purpose, usually transducers (encoder, tachogenerator, resolver, etc.) are installed on the shaft. However, transducers are not preferred in most of the applications since they increase the cost and decrease the reliability of the drive due to their failure prone structure and connections. In such applications, the spee...
Experimental investigation of tip anhedral effects on the aerodynamics of a model helicopter rotor in hover
Uluocak, Sinem; Perçin, Mustafa; Uzol, Oğuz (2021-06-01)
This study experimentally investigates the effects of tip anhedral on the rotor aerodynamic performance and the tip vortex characteristics in hovering flight. A five-bladed scaled helicopter rotor with blades that have either rectangular (baseline) or anhedral tip geometries was used as the experimental model. Thrust and torque measurements were performed at the tip Mach numbers (Mtip) of 0.3 and 0.4 at five different pitch angles. In addition, flow field measurements via phase-locked particle image velocim...
Citation Formats
O. E. Yagiz, K. Albayrak, and R. O. Yidirim, “Experimental investigation of three rotating parachutes,” JOURNAL OF AIRCRAFT, pp. 1574–1577, 2006, Accessed: 00, 2020. [Online]. Available: https://hdl.handle.net/11511/31091.