Spectroscopic measurements of electron temperature and electron density in electron beam plasma generator based on collisional radiative model

Date

2007-01-01

Author

Goktas, H.
Demir, A.
Kacar, E.
Hegazy, H.
Turan, Raşit
Oke, G.
Seyhan, A.

Metadata

Show full item record

This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

Item Usage Stats

317
views

0
downloads

The current work describes a spectroscopic method for determining the electron temperature and electron density in an electron beam generator using argon spectral lines based on a collisional radiative model. Neutral and first-ionized Ar lines emitted from the electron beam generator are studied experimentally. A collisional radiative code was developed to simulate the Ar (I) and Ar (II) spectral emission and to compare the results with the experimental data for electron density and temperature determination. At lines and excited level densities were calculated by solving rate equations using the Gauss elimination method. The argon spectrum is recorded experimentally by superposing two discharges, namely a low pressure DC glow discharge and a high current pulsed discharge. Spectral lines between 350 nm and 950 nm were recorded using an integrated signal technique on a charge-coupled device. Electron temperature is determined by the relative intensity ratio method of two spectral lines. The relative intensity ratios of each peak are compared in a specific pressure range at various values, and good correlation is reported.

Subject Keywords

Analytical Chemistry, Spectroscopy, Atomic and Molecular Physics, and Optics

URI

https://hdl.handle.net/11511/41090

Journal

SPECTROSCOPY LETTERS

DOI

https://doi.org/10.1080/00387010600934469

Collections

Department of Physics, Article

Suggestions

OpenMETU
Core

Raman Spectroscopy Investigation of Nano Hydroxyapatite Doped with Yttrium and Fluoride Ions Yilmaz, Bengi; Evis, Zafer (Informa UK Limited, 2014-01-02) In this study, nano hydroxyapatite doped with yttrium (2.5, 5, and 7.5mol%) and fluoride (2.5mol%) ions were synthesized by precipitation method and sintered at 900 degrees C, 1100 degrees C, and 1300 degrees C. Raman spectroscopy was applied to track the structural modifications in pure and doped hydroxyapatites. The results showed that the main characteristic band of pure hydroxyapatite at 963cm(-1) was not affected significantly by ion doping but exhibited higher intensity with increasing sintering tempe...
Spectroscopic modification of the Pippard relation applied for the translational mode in ammonia solid II near the melting point Yurtseven, Hasan Hamit; Yıldız, İlker (Elsevier BV, 2005-09-01) This study gives our calculation for the frequency shifts 1/V(partial derivative v/partial derivative T)(P) and the specific heat C-p near the melting point in the ammonia solid II. We establish a linear relationship between C-p and 1/v(partial derivative v/partial derivative T)(P) using the Raman frequencies of the translational mode which we calculated in this system. This leads to the validity of the spectroscopic modification of the first Pippard relation in the ammonia solid II near the melting point. ...
Electronic properties of a large quantum dot at a finite temperature Gulveren, B; Atav, U; Tomak, Mehmet (Elsevier BV, 2005-09-01) The physical properties of a two-dimensional parabolic quantum dot composed of large number of interacting electrons are numerically determined by the Thomas Fermi (TF) method at a finite temperature. Analytical solutions are given for zero temperature for comparative purposes. The exact solution of the TF equation is obtained for the non-interacting system at finite temperatures. The effect of the number of particles and temperature on the properties are investigated both for interacting and non-interactin...
Performance of banded SLW-1 in presence of non-gray walls and particles in fluidized bed combustors Yaşar, Mehmet Soner; Selçuk, Nevin; Külah, Görkem (Elsevier BV, 2020-12-01) In this study, banded one gas spectral line-based weighted sum of gray gases (banded SLW-1) model is coupled with a 3-D radiation code based on method of lines (MOL) solution of discrete ordinates method (DOM) for freeboard of METU 0.3 MWt atmospheric bubbling fluidized bed combustion (ABFBC) test rig containing non-gray gas, non-gray particle mixture bounded by non-gray walls. Spectral parameters of banded SLW-1 are estimated by the approach based on two emissivities calculated at two different path length...
Nondipolar effects in the photoionization dynamics of carbon tetrafluoride Toffolı, Danıele; Decleva, Piero (American Physical Society (APS), 2008-12-01) The linear combination of atomic orbitals approach to the calculation of the molecular continuum spectrum with B-spline basis functions has been applied to the calculation of the first-order nondipolar corrections to the photoelectron angular distributions from carbon tetrafluoride. Dipolar and nondipolar asymmetry parameter profiles have been calculated for every single-particle orbital ionization. A comparison with the available experimental data gives good agreement for the dipolar asymmetry parameter. N...

Citation Formats

H. Goktas et al., “Spectroscopic measurements of electron temperature and electron density in electron beam plasma generator based on collisional radiative model,” SPECTROSCOPY LETTERS, pp. 183–192, 2007, Accessed: 00, 2020. [Online]. Available: https://hdl.handle.net/11511/41090.