DEVELOPMENT OF AN EXPERT-SYSTEM FOR DRAGLINE AND STRIPPING METHOD SELECTION

IMPROVEMENT IN THE IMPACT TOUGHNESS OF ALUMINUM FIBREGLASS COMPOSITES SELCUK, E (1994-08-25)
AN EVALUATION OF RECRYSTALLIZATION TEXTURES IN ROLLED CU-ZN ALLOYS OZTURK, T (1988-04-01)
EXPERIMENTAL AND THEORETICAL-STUDY OF SHORT ORDER IN NI-OS AND CO-OS ALLOYS KATSNELSON, AA; Mehrabov, Amdulla; SILONOV, VM (1979-01-01)
Development of an algorithm for material selection Seyis, Önder; Atala, Haluk; Department of Metallurgical and Materials Engineering (2005) Material selection is one of the major points that should be taken into account seriously in the engineering design stage. Each material has various properties such as mechanical, thermal, electrical, physical, environmental, optical and biological properties. However, it is a well known fact that only a limited number of design engineers have a thorough knowledge on all these properties of a specific material, which is planned to be used in the manufacturing of the product. Therefore, the design engineer s...
Development of lead alloys for valve-regulated lead-acid (VRLA) batteries Halıcı, Şafak; Aydınol, Mehmet Kadri; Department of Metallurgical and Materials Engineering (2010) In this study, Mg, Sn, Cd, Bi and Sb containing, five binary, three ternary and two quaternary different alloys to be used in a Valve-Regulated Lead-Acid (VRLA) batteries have been studied in terms of their mechanical and electrochemical properties. The investigated properties are hardness, passivity, corrosion rate, hydrogen gassing and the conductivity of the passive film. All electrochemical tests were carried out in 3.75 M H2SO4 solution by using open-circuit potential, anodic polarization, polarization...

Citation Formats

B. ERDEM, N. CELEBI, and A. PASAMEHMETOGLU, “DEVELOPMENT OF AN EXPERT-SYSTEM FOR DRAGLINE AND STRIPPING METHOD SELECTION,” 1994, p. 595, Accessed: 00, 2020. [Online]. Available: https://hdl.handle.net/11511/66230.