Comparison of transient and quasi-steady aeroelastic analysis of wind turbine blade in steady wind conditions

Download
index.pdf
2014-06-01
Sargın, Hakan
Kayran, Altan
Show full item record
132
views
80
downloads
https://hdl.handle.net/11511/84415
Journal of Physics: Conference Series
Unclassified, Article

Suggestions

Comparison of transient and quasi-steady aeroelastic analysis of wind turbine blade in steady wind conditions
Sargın, H; Kayran, Altan (2014-6-16)
In the preliminary design stage of wind turbine blade, faster and simpler methods are preferred to predict the aeroelastic response of the blades in order to get an idea about the appropriateness of the blade stiffness. Therefore, in the present study, applicability of the quasi-steady aeroelastic analysis of wind turbine blade is investigated in terms of how accurately the quasi-steady aeroelastic analysis predicts the deformed state of the blade at certain azimuthal positions. For this purpose, compa...
Comparison of magnetic Barkhausen noise and ultrasonic velocity measurements for microstructure evaluation of SAE 1040 and SAE 4140 steels
Gür, Cemil Hakan; Çam, İbrahim (Elsevier BV, 2007-05-01)
The aim of this study is to compare the performance of magnetic Barkhausen noise and ultrasonic methods for the evaluation of the microstructure of commercial steels. Following the austenitization of the specimens made of SAE 1040 and SAE 4140, various heat treatments were carried out to obtain microstructures consisting of martensite, tempered martensite, fine pearlite-ferrite, and coarse pearlite-ferrite. The microstructures were initially characterized by SEM investigation and hardness measurements. The ...
Comparison of hydrometer method and laser diffractometry in determining grain size distribution of clayey soils
Karabıyıkoğlu, Mithat; Mirata, Türker; Department of Civil Engineering (2001)
Comparison of Electronic Speckle Laser Interferometry Hole-Drilling and X-ray Diffraction Techniques for Determination of Residual Stresses in the Heat Treated Steels
HIZLI, HÜSEYİN; Gür, Cemil Hakan (2017-06-01)
Carburizing is widely used to improve wear resistance and fatigue life of high duty machine parts. Fatigue performance of the carburized components is greatly dependent on the residual stress state in the surface layer. The aim of this paper is to measure the depth profiles of residual stresses in the carburized steels by electronic speckle laser interferometry (ESPI) assisted hole-drilling, and to compare the results with those measured by X-ray diffraction technique. To comprehend the differences in the r...
Comparison of anaerobic acrylic acid biotransformation in single- and two-stage pH-stat completely stirred tank reactor systems
Demirer, Göksel Niyazi; Speece, RE (Wiley, 2000-01-01)
Performance of single- and two-stage pH-stat completely stirred tank reactor (CSTR) systems for anaerobic acrylic acid biotransformation was investigated and compared. In the experiments, acetate was added with acrylic acid. Acetate concentration in both single- and two-stage reactors was continuously maintained at a nonlimiting concentration of 2000 +/- 200 mg/L. using a computer-controlled pH-stat system to allow observation of the effect of acrylate biotransformation on the more sensitive methanogenic st...
Citation Formats
H. Sargın and A. Kayran, “Comparison of transient and quasi-steady aeroelastic analysis of wind turbine blade in steady wind conditions,” Journal of Physics: Conference Series, pp. 1–11, 2014, Accessed: 00, 2021. [Online]. Available: https://hdl.handle.net/11511/84415.
METU IIS - Integrated Information Service open@metu.edu.tr