Thermal Analysis of Order-Disorder Phase Transformations in B2-type Ordered Fe-Al-X Intermetallics

Date

2007-10-21

Author

Yıldırım, Mehmet
Akdeniz, Mahmut Vedat
Mehrabov, Amdulla

Metadata

Show full item record

Item Usage Stats

41
views

0
downloads

URI

https://hdl.handle.net/11511/84457

Collections

Unverified, Conference / Seminar

Suggestions

OpenMETU
Core

Thermal characterisation of quantum cascade lasers with Fabry Perot modes Gundogdu, Sinan; Pisheh, Hadi Sedaghat; Demir, Abdullah; Guenoven, Mete; AYDINLI, ATİLLA; Sirtori, Carlo (2018-04-26) Quantum cascade lasers are coherent light sources that rely on intrersubband transition in periodic semiconductor quantum well structures. They operate at frequencies from mid-infrared to terahertz. In cases of long wavelength and typical low thermal conductivity of the active region, temperature rise in the active region during operation is a major concern. Thermal conductivity of QCL epi-layers differ significantly from the values of bulk semiconductors and measurement of the thermal conductivity of epi-l...
Thermal analysis of eutectic modified and grain refined aluminum-silicon alloys İslamoğlu, H. Erol; Kalkanlı, Ali; Department of Metallurgical and Materials Engineering (2005) A series of AlSi9Mg alloys were prepared and tested to reveal the effect of addition sequence and timing of grain refiner and eutectic modifier. AlSr10 master alloy was used as an modification reagent, and also for grain refiner AlTi5B master alloy was used. The depression at the eutectic temperature due to the addition of modifier and decrease in the amount of undercooling at the liquidus due to the presence of grain refiner were examined by the cooling curves which were obtained by the Alu-Therm instrumen...
Thermal characterization and model-free kinetics of biodiesel sample Kök, Mustafa Verşan (2015-11-01) In this study, combustion and pyrolysis behaviours of methanol route biodiesel were investigated using thermal analysis techniques known as simultaneous thermogravimetry and differential scanning calorimetry (DSC) at different heating rates. Reaction regions, peak temperatures, mass loss and heat flow rates of the biodiesel sample are determined using TG-DTG and DSC data. It was found that as the heating rate of the reactions increased, peak temperatures of the reactions shifted higher temperatures, implyin...
Thermal characterization of glycidyl azide polymer (GAP) and GAP-based binders for composite propellants Selim, K; Özkar, Saim; Yılmaz, Levent (Wiley, 2000-07-18) Differential scanning calorimetry (DSC) and thermal gravimetric analysis (TGA) were used to investigate the thermal behavior of glycidyl azide polymer (GAP) and GAP-based binders, which are of potential interest for the development of high-performance energetic propellants. The glass transition temperature (T-g) and decomposition temperature (T-d) of pure GAP were found to be -45 and 242 degrees C, respectively. The energy released during decomposition (Delta H-d) was measured as 485 cal/g. The effect of th...
Thermal effects of gate connected field-plates and surface passivation on AlGaN/GaN HEMTs Kara, Doğacan; Okutucu Özyurt, Hanife Tuba; Dönmezer, Nazlı; Department of Mechanical Engineering (2018) AlGaN/GaN high electron mobility transistors (HEMTs) are widely preferred in automotive, space, and military applications due to their superior electrical and thermal properties. However, when operated in full capacity, their electrical reliability drops significantly due to electron collapse, device degradation, concentrated heating, and mechanical stresses. To increase the reliability and maximum performance of GaN HEMTs, field-plate and surface passivation technologies are used frequently. Although signi...

Citation Formats

M. Yıldırım, M. V. Akdeniz, and A. Mehrabov, “Thermal Analysis of Order-Disorder Phase Transformations in B2-type Ordered Fe-Al-X Intermetallics,” 2007, Accessed: 00, 2021. [Online]. Available: https://hdl.handle.net/11511/84457.