Experimental validation of the heat pipe evaluation software “Heat Pipe Analysis Toolbox (H-PAT)”

Date

2021-05-18

Author

Saygan, Samet
Akkuş, Yigit
Çetin, Barbaros
Dursunkaya, Zafer

Metadata

Show full item record

This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

Item Usage Stats

244
views

0
downloads

URI

https://hdl.handle.net/11511/91584

Conference Name

13th ICCHMT 2021

Collections

Department of Mechanical Engineering, Conference / Seminar

Suggestions

OpenMETU
Core

Experimental performance evaluation of direction finding by amplitude comparison for GSM applications / Karadağ, Savaş; Demir, Şimşek; Department of Electrical and Electronics Engineering (2014) In this thesis, radio direction finding (DF) systems are examined, implementation and measurements for GSM mobile phones are done by using 6-element uniform circular Vivaldi antenna array and uniform circular monopole antenna array which is used asWatsonWatt antenna. Although degrading in performance of DF is expected, only one receiver unit is used in angle-of-arrival (AOA) to measure received signal strength (RSS) from each antenna elements to obtain low cost and small sized set-up. Moreover three di eren...
Experimental validation of pseudo receptance difference (PRD) method for nonlinear model updating Canbaloglu, Guvenc; Özgüven, Hasan Nevzat (Springer, 2015-02-05) In real life applications most of the structures have nonlinearities, which restrict us applying model updating techniques available for linear structures. Well-established FRF based model updating methods would easily be extended to a nonlinear system if the FRFs of the underlying linear system (linear FRFs) could be experimentally measured. When frictional type of nonlinearity co-exists with other types of nonlinearities, it is not possible to obtain linear FRFs experimentally by using low level forcing. ...
Experimental evaluation of geomembrane / geotextile interface as base isolating system Taheri Bonab, Amin; Gülerce, Zeynep; Kalpakcı, Volkan; Department of Civil Engineering (2016) The objective of this study is to evaluate the effect of the composite liner seismic isolation system on the seismic response of small-to-moderate height structures. For this purpose, a building model with the natural frequency of 3.13 Hz (representing 3-4 story structures) was tested with and without the addition of composite liner system using the shaking table test set-up by employing harmonic and modified/ scaled ground motions. Experiment results showed that the composite liner seismic isolation system...
Experimental evaluation of geomembrane/geotextile interface as base isolating system Kalpakci, V.; Bonab, A. T.; Özkan, M. Yener; Gülerce, Zeynep (Thomas Telford Ltd., 2018-02-01) The objective of this study is to evaluate the effect of the geomembrane/geotextile interface on the seismic response of small-to-moderate height structures. Three building models with first-mode natural frequencies changing between 2-4 Hz (representing two, three and four storey structures) were tested with and without the addition of geomembrane/geotextile interface using the shaking table test setup by employing harmonic and modified/ scaled ground motions. Experimental results showed that the geomembran...
Experimental characterization of collapse-mode CMUT operation Oralkan, Omer; Bayram, Barış; Yaralioglu, Goksen G.; Ergun, A. Sanli; Kupnik, Mario; Yeh, David T.; Wygant, Ira O.; Khuri-Yakub, Butrus T. (2006-08-01) This paper reports on the experimental characterization of collapse-mode operation of capacitive micromachined ultrasonic transducers (CMUTs). CMUTs are conventionally operated by applying a direct current (DC) bias voltage less than the collapse voltage of the membrane, so that the membrane is deflected toward the bottom electrode. In the conventional regime, there is no contact between the membrane and the substrate; the maximum alternating current (AC) displacement occurs at the center of the membrane. I...

Citation Formats

S. Saygan, Y. Akkuş, B. Çetin, and Z. Dursunkaya, “Experimental validation of the heat pipe evaluation software “Heat Pipe Analysis Toolbox (H-PAT)”,” presented at the 13th ICCHMT 2021, Paris, Fransa, 2021, Accessed: 00, 2021. [Online]. Available: https://hdl.handle.net/11511/91584.