Development and testing of an existing ballistic type medium-speed impact device

Download
035545.pdf
1994
Görateş, Mesut
Show full item record
66
views
0
downloads
https://hdl.handle.net/11511/9591
Graduate School of Natural and Applied Sciences, Thesis

Suggestions

Development and production of ductile TiZrNbHfTa refractory high entropy alloy system for extreme environments
İroç, Lütfi Koray; Aydoğan Güngör, Eda; Kalay, Yunus Eren; Department of Metallurgical and Materials Engineering (2022-1-13)
High entropy alloy (HEA) is a trending material class that was discovered in the early 2000s. By definition, it consists of a single or dual phase by combining 5-13 elements with a 5-35% atomic ratio. They exhibit extraordinary properties, such as structural, mechanical, corrosive and thermal. Moreover, this field gives an opportunity to combine infinite number of elements with infinite compositions. These properties and opportunities make them candidates for various extreme application areas, which will gr...
Development and experimental verification of a structural health monitoring system for composite beams with embedded fibre bragg grating sensors
Değerliyurt, Boray; Şahin, Melin; Department of Aerospace Engineering (2017)
Structural Health Monitoring (SHM) is a discipline of development and application of monitoring and detecting adverse changes and damage in a structure in operation. This study explains development of a SHM system of composite beams with embedded Fibre Bragg Grating (FBG) sensors and its verification through experiments. There are considerations that require attention during manufacturing of composite specimens with embedded sensors. During manufacturing, protective teflon tubes are added to the ingress and...
Development, design and realization of a television transposer test unit employing microprocessor for remote measurement and testing
Tezcan, Hasan Hüseyin; Bengi, Halil; Department of Electrical and Electronics Engineering (1987)
Design and manufacturing of a high speed, jet powered target drone
Özyetiş, Ender; Alemdaroğlu, Hüseyin Nafiz; Department of Aerospace Engineering (2013)
This thesis presents the design and manufacturing of a high speed jet powered UAV which is capable of flying at M=0.5. Flight time of the UAV is 30 minutes at 1700 m above sea level. Aerodynamic and structural design of the UAV is conducted for 6g sustained and 9g instantaneous loads. Low aspect ratio blended wing-body design is decided due to low drag and high maneuverability. The Structure of the UAV consists of the composite parts such as frames and skin and mechanical parts such as landing gears which a...
Development and implementation of novel flow control techniques for nonslender delta wings
Çelik, Alper; Yavuz, Mehmet Metin; Department of Mechanical Engineering (2017)
Understanding and controlling the physical phenomenon behind the aerodynamics of low to moderate swept delta wings has been a challenge for researchers during the last few decades, which is stimulated by their widespread use in unmanned combat air vehicles (UCAVs) and micro air vehicles (MAVs). Although delta wings are capable of generating high lift and stable flight performance at high angle of attack, the problems related to lack of conventional flow control surfaces compel the researchers to explore new...
Citation Formats
M. Görateş, “Development and testing of an existing ballistic type medium-speed impact device,” Middle East Technical University, 1994.
METU IIS - Integrated Information Service open@metu.edu.tr