Cost analysis for seaport

Download
035744.pdf
1994
Yalçındağ, Kaan
Show full item record
132
views
0
downloads
https://hdl.handle.net/11511/10210
Graduate School of Natural and Applied Sciences, Thesis

Suggestions

Cost analysis of water treatment plants by computer
Sen, A Cem; Uluatam, Semra S.; Department of Civil Engineering (1991)
Cost estimation of housing projects by functional areas
Öncül, Mustafa; Arıkan, Metin S.; Department of Civil Engineering (2006)
Good conceptual cost estimates is one of the most important factors affecting the project success. Investment decisions taken and budget preparations are performed from the results of the conceptual estimates. Also, the most difficult cost estimation is the early estimates where there is very limited information. This thesis provides a model for the cost estimation of the housing projects at the conceptual stage, considering not only the total area of the construction, but also considering fractional areas,...
Cost assessment of construction projects through neural networks
Gulcicek, Umit; Ozkan, Omer; Gunduz, Murat; DEMİR, İSMAİL HAKKI (Canadian Science Publishing, 2013-06-01)
Construction performance parameters have experienced greater international attention and discussion in recent years. In this study, the change in the load-bearing system cost of a reinforced concrete housing estate building was investigated in relation to the building importance factor, earthquake region, soil type, floor area, and the number of stories. Three different housing estate projects with seven and fifteen stories were investigated. The structural design calculations were performed according to fo...
Cost assessment of concrete and steel types for office buildings: An exploratory study
Kanit, Recep; Ozkan, Omer; Gunduz, Murat (Elsevier BV, 2007-09-01)
This paper presents a set of regression models which incorporates concrete and steel types in modeling the costs of office buildings. To these ends, three typical office buildings with seven and 15 stories have been designed by the help of a commercial software taking into account the Turkish practice. In each project C-16, C-20, C-25, C-30 and C-35 concrete classes and S-220 and S-420 steel types were used for dimensioning purposes. Rough construction costs were then calculated for different combinations o...
Cost analysis wastewater treatment systems by computer programming
Barutoğlu, Erhan; Uluatam, Semra S.; Department of Civil Engineering (1991)
Citation Formats
K. Yalçındağ, “Cost analysis for seaport,” Middle East Technical University, 1994.
METU IIS - Integrated Information Service open@metu.edu.tr