The optimum spacing between parallel heat generating boards cooled by forced convection

Download
116147.pdf
2001
Ekici, Özgür
Show full item record
68
views
0
downloads
https://hdl.handle.net/11511/10889
Graduate School of Natural and Applied Sciences, Thesis

Suggestions

The Optimum spacing between parallel heat generating boards cooled by natural convection
Eryurt, Koray; Yüncü, Hafit; Department of Mechanical Engineering (2001)
The optimum die profile for the cylindrical bending of plates
Oral, S; Darendeliler, Haluk (1997-10-01)
This paper presents a methodology for the design of plate-forming dies in cylindrical bending using optimization techniques to reduce the cost of die production by reducing the trial-and-error procedure considerably in determining the final die geometry. The plate thickness is discretized by plane-strain finite-elements. The die is taken to be rigid and its profile is approximated by Bezier curves the control-point coordinates of which are the design variables. The die profile is varied to minimize the diff...
THE OPTIMUM TAPER ANGLE FOR ETHANOL FERMENTATION IN A PACKED-BED COLUMN REACTOR
COLAK, T; Hamamcı, Haluk (1991-01-01)
In ethanol fermentation, tapered columns facilitate the liberation of CO2 and, since the bed expands through a larger cross-sectional area, smaller pressure drops occur. In this work, 0-degrees, 2-degrees, and 4-degrees tapered columns, containing Saccharomyces cerevisiae entrapped in beads of kappa-carrageenan, were operated for continuous production of ethanol from glucose. The column inlet diameters and the bead volume were maintained constant for the three columns. With decreasing taper angle, increa...
The vibratory loads of an optimized helicopter rotor at off design conditions
Aykut, Tamer; Evren, Taşkınoğlu; Yaman, Yavuz (null; 2012-06-19)
The high-frequency limit of usable response spectral ordinates from filtered analogue and digital strong-motion accelerograms
Akkar, Dede Sinan; Kale, Ozkan; Yenier, Emrah; Bommer, Julian J. (Wiley, 2011-10-01)
The range of response frequencies for which spectral ordinates obtained from accelerograms may be considered reliable is limited by several factors, primary among them being the effects of filters that are routinely applied to remove noise from the records. Considerable attention has been focused on the low-frequency limit of the usable spectral ordinates because of various engineering applications requiring long-period spectral accelerations or displacements but only recently have rational approaches to se...
Citation Formats
Ö. Ekici, “The optimum spacing between parallel heat generating boards cooled by forced convection,” Middle East Technical University, 2001.
METU IIS - Integrated Information Service open@metu.edu.tr