Theoretical and experimental investigation on electric discharge machining.

1977
Erden, Abdülkadir
Show full item record
136
views
0
downloads
Electric metal-cutting.
https://hdl.handle.net/11511/11934
Graduate School of Natural and Applied Sciences, Thesis

Suggestions

Theoretical and experimental investigation of bulk glass forming ability in bulk amorphous alloy systems
Ayas, Can; Mekrabov, Amdulla O.; Department of Metallurgical and Materials Engineering (2005)
In this study molecular dynamics simulation program in NVT ensemble using Velocity Verlet integration was written in order to investigate the glass forming ability of two metallic systems. The Zn-Mg system, one of the frontiers of simple metal-metal metallic glasses and Fe-B, inquiring attention due to presence of many bulk glass forming alloy systems evolved from this binary with different alloying element additions. In addition to this, atomistic calculations on the basis of ordering were carried out for ...
Finite element analysis of orthogonal metal cutting operations
Usta, Mustafa; Kılıç, S. Engin; Department of Mechanical Engineering (1999)
Development of lead alloys for valve-regulated lead-acid (VRLA) batteries
Halıcı, Şafak; Aydınol, Mehmet Kadri; Department of Metallurgical and Materials Engineering (2010)
In this study, Mg, Sn, Cd, Bi and Sb containing, five binary, three ternary and two quaternary different alloys to be used in a Valve-Regulated Lead-Acid (VRLA) batteries have been studied in terms of their mechanical and electrochemical properties. The investigated properties are hardness, passivity, corrosion rate, hydrogen gassing and the conductivity of the passive film. All electrochemical tests were carried out in 3.75 M H2SO4 solution by using open-circuit potential, anodic polarization, polarization...
An investigation of the microstructural and mechanical properties of tri-calcium phosphates doped with aluminum and fluoride ions
Tahmasebifar, Aydin; Evis, Zafer; Department of Engineering Sciences (2011)
The aim of this study was to investigate the microstructure and mechanical properties of pure tricalcium phosphate (TCP) and tricalcium phosphates doped with aluminum (Al3+) and fluoride (F-) ions at different compositions. TCP was synthesized via precipitation method and sintered at 1100C for 1 and 5 h. It was observed that density and relative density of the sintered materials were decreased by extending the sintering time. Increased densities were achieved upon Al3+ and/or F- doping. For structural anal...
Development of an algorithm for material selection
Seyis, Önder; Atala, Haluk; Department of Metallurgical and Materials Engineering (2005)
Material selection is one of the major points that should be taken into account seriously in the engineering design stage. Each material has various properties such as mechanical, thermal, electrical, physical, environmental, optical and biological properties. However, it is a well known fact that only a limited number of design engineers have a thorough knowledge on all these properties of a specific material, which is planned to be used in the manufacturing of the product. Therefore, the design engineer s...
Citation Formats
A. Erden, “Theoretical and experimental investigation on electric discharge machining.,” Ph.D. - Doctoral Program, Middle East Technical University, 1977.
METU IIS - Integrated Information Service open@metu.edu.tr