Effects of synthesis, doping methods and metal content on thermoluminescence glow curves of lithium tetraborate

Date

2011-07-28

Author

Kayhan, Mehmet
Yılmaz, Ayşen

Metadata

Show full item record

This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

Item Usage Stats

226
views

0
downloads

Lithium tetraborate: Li(2)B(4)O(7), (LTB) has been synthesized and doped with various Mn content by different methods, such as, high temperature solid state synthesis and solution assisted synthesis methods. Powder XRD results proved the formation of solid-solution by replacing Mn with Li ions in LTB lattice at lower amount of Mn doping, for example 0.1-3.0% Mn doping. In this research TL glow curves of Mn doped lithium tetraborate (LTB: Mn) produced by using different synthesis and doping methods and the effects of Ag, P and Mg as co-dopant were investigated. Structural and morphological analyses of products were done by using Fourier Transform Infrared spectroscopy (FTIR), Powder X-Ray Diffraction (XRD), Scanning Electron Microscopy (SEM), Transmission Electron Microscopy (TEM) and Raman Spectroscopy.

Subject Keywords

Mechanical Engineering, Materials Chemistry, Mechanics of Materials, Metals and Alloys

URI

https://hdl.handle.net/11511/38325

Journal

JOURNAL OF ALLOYS AND COMPOUNDS

DOI

https://doi.org/10.1016/j.jallcom.2011.04.137

Collections

Department of Chemistry, Article

Suggestions

OpenMETU
Core

The structural and electronic properties of BAs and BP compounds and BPxAs1-x alloys Mohammad, Rezek; Katırcıoğlu, Şenay (Elsevier BV, 2009-10-19) The structural and electronic properties of BAs and BP compounds and BPxAs1-x alloys have been investigated by full potential linearized augmented plane wave (FP-LAPW) method based on DFT The total energies and electronic band structures of these compounds have been calculated for different approximations of exchange-correlation energy. The comparative study has showed that the PW-GGA is the best one to produce the measured structural quantities of the compounds. such as the lattice constant, bulk modulus, ...
Effect of lithium doping on the properties of Tl-based superconductors Kayed, TS; Ozkan, H; Hasanlı, Nızamı (IOP Publishing, 2001-09-01) The effects of lithium doping on the formation and properties of the T1-based superconductors have been studied. Lithium atoms up to around 3 mol.% have been added to the oxides of nominal composition Tl1.8Ba2Ca2.2Cu3Ox, and the usual solid-state reaction method has been applied. Lithium additions in the range 0.23-0.29 mol.% increase the fraction of the Tl-2223 phase and significantly improve the critical temperature of the samples. Higher amounts of lithium additions diminish the Tl-2223 phase, reduce the...
Enhancement in the high-T-c phase of BSCCO superconductors by Nb addition Sozeri, Huseyin; Ghazanfari, Nader; Ozkan, Husnu; Kilic, Ahmet (IOP Publishing, 2007-06-01) Pure and Nb2O5 added Bi1.6Pb0.4Nbx Sr2Ca2Cu3O delta superconductors ( x varies up to 0.30) were synthesized by the solid state reaction method. Structural and superconducting properties of the samples were investigated. The fraction of the high-T-c phase ( 2223) increases with Nb addition up to x = 0.10, for which a nearly single 2223 phase was obtained. The critical temperature of the samples increases from 96 to 104 K with doping up to x = 0.20 and a further increase in Nb decreases the Tc sharply. Simila...
Mechanochemical and volume combustion synthesis of ZrB2 Akgun, Baris; ÇAMURLU, HASAN ERDEM; Topkaya, Yavuz Ali; SEVİNÇ, NACİ (Elsevier BV, 2011-09-01) Formation of ZrB2 by volume combustion synthesis (VCS) and mechanochemical process (MCP) from ZrO2-Mg-B2O3 was studied. Production of ZrB2 by VCS in air occurred with the formation of side products, Zr2ON2 and Mg3B2O6 in addition to MgO and ZrB2. Zr2ON2 formation was prevented by conducting VCS experiments under argon. Wet ball milling was applied to the VCS products before leaching for easier removal of Mg3B2O6 phase. MgO and Mg3B2O6 were removed from wet ball-milled products by leaching in 5 M HCI for 2.5...
Synthesis, characterization, and electrochromic properties of conducting poly(hexanedioic acid bis-(2-thiophen-3-yl-ethyl ester) and its copolymer with thiophene CAMURLU, P; Çırpan, Ali; Toppare, Levent Kamil (Elsevier BV, 2004-10-14) Hexanedioic acid bis-(2-thiophen-3-yl-ethyl) ester (HABTE) was synthesized via the reaction of 3-thiophene ethanol with adipoyl chloride. Resulting monomer was electrochemically homopolymerized in the presence of tetrabutylammonium tetrafluoroborate as the supporting electrolyte, in acetonitrile/borontrifloride ethylether solvent mixture (8:2, v/v). Copolymerization in the presence of thiophene was achieved in TBAFB/AN. Resulting homo and copolymers were characterized via CV, FTIR, DSC, TGA, SEM, and UV-vis...

Citation Formats

M. Kayhan and A. Yılmaz, “Effects of synthesis, doping methods and metal content on thermoluminescence glow curves of lithium tetraborate,” JOURNAL OF ALLOYS AND COMPOUNDS, pp. 7819–7825, 2011, Accessed: 00, 2020. [Online]. Available: https://hdl.handle.net/11511/38325.