Modeling studies on a packed distillation column.

1983
Sümer, Ali
Show full item record
34
views
0
downloads
https://hdl.handle.net/11511/4475
Graduate School of Natural and Applied Sciences, Thesis

Suggestions

Modeling and control studies for a reactive batch distillation column
Bahar, Almıla; Özgen, Canan; Department of Chemical Engineering (2007)
Modeling and inferential control studies are carried out on a reactive batch distillation system for the esterification reaction of ethanol with acetic acid to produce ethyl acetate. A dynamic model is developed based on a previous study done on a batch distillation column. The column is modified for a reactive system where Artificial Neural Network Estimator is used instead of Extended Kalman Filter for the estimation of compositions of polar compounds for control purposes. The results of the developed dyn...
Modeling and computational experiment on gain characteristics of CO2 lasers.
Kalay, Yaşar; Department of Electrical and Electronics Engineering (1992)
Modeling and performance improvements of a pressure compensated axial piston pump
Aydoğan, Okan; Balkan, Raif Tuna; Department of Mechanical Engineering (2018)
Analysis of internal dynamics of a pressure compensated axial piston pump has an importance to predict the pump characteristics. In order to accomplish this mission physical model is developed to simulate pump pressure-flow characteristics for a given set of system parameters in Matlab/Simulink environment. The pump is modeled as two main groups, namely, pumping section, and compensation section. Pistons are orderly nested in cylinder block around shaft axis in the pump. In the pumping section model, multi-...
Modeling and experimental identification of quadrotor aerodynamics
Kaya, D. Derya; Kutay, Ali Türker; Department of Aerospace Engineering (2014)
The aim of this study is to obtain mathematical models for aerodynamic forces and moments of rotors of a quadrotor helicopter, and estimate their parameters through wind tunnel tests for hover, vertical climb, and forward flight conditions. The main factors which determine the movement of a quadrotor UAV are the aerodynamic forces and moments in three axes created by four rotors of the vehicle. Hence, accurate calculation of rotor forces and moments in varying flight conditions are essential to establish a ...
Modeling and verification of a missile launcher system
Isik, C.; Ider, S. K.; Acar, B. (SAGE Publications, 2014-03-01)
The launcher models used in most of the previous studies have few degrees of freedom that cannot possibly capture many important motion characteristics. In this work, a flexible multibody model of a missile launcher system is built. The fixed, azimuth and elevation platforms and the launching pod are modeled as flexible bodies. Both the normal vibration modes and constraint modes are considered. Modes that do not contribute significantly to the total strain energy are eliminated to reduce simulation time. T...
Citation Formats
A. Sümer, “Modeling studies on a packed distillation column.,” Middle East Technical University, 1983.
METU IIS - Integrated Information Service open@metu.edu.tr