Micro-CT and nano-CT analysis of filling quality of three different endodontic sealers

Huang, Yan
Vasconcelos, Karla de Faria
Pinheiro Nicolielo, Laura Ferreira
Lippiatt, Nicholas
Büyüksungur, Arda
Jacobs, Reinhilde
Objectives: To investigate voids in different root canal sealers using micro-CT and nano-CT, and to explore the feasibility of using nano-CT for quantitative analysis of sealer filling quality.


Solvent-free microwave extraction of essential oil from oregano
Bayramoglu, Beste; Şahin, Serpil; Şümnü, Servet Gülüm (2008-10-01)
Applicability of solvent-free microwave extraction (SFME) in the extraction of essential oil from Origanum vulgare L. was examined and the effects of microwave power and extraction time on the yield and composition of the product were investigated. Specific gravity and refractive index of the essential oil and its solubility in alcohol were also examined. Hydrodistillation was performed as control. GC-MS/FID was used for the determination and quantification of aroma compounds in the essential oils. SFME off...
Microwave Assisted Extraction of Phenolic Compounds from Sour Cherry Pomace
Simsek, Meric; Şümnü, Servet Gülüm; Şahin, Serpil (2012-01-01)
Microwave assisted extraction of sour cherry pomace at different conditions were compared with conventional extraction in terms of total phenolic content and antiradical efficiency. Total phenolic content and antiradical efficiency at the optimum conditions (700 W, ethanol-water, 12 min, 20 mL solvent/ g solid) of microwave assisted extraction were 14.14 mg GAE/g sample and 28.32 mg DPPH center dot/g sample, respectively. Total phenolic content and antiradical efficiency of extracts obtained by conventional...
Solvent extraction of scandium from pregnant leach solution of nickel laterites
Ferizoğlu, Ece; Gürbüz, Rıza; Topkaya, Yavuz Ali; Department of Metallurgical and Materials Engineering (2017)
The aim of this thesis study is the extraction and recovery of scandium from lateritic nickel-cobalt ores by using the solvent extraction method. In this study, different organic and scrubbing reagents were investigated in order to find the most suitable organic extractant for the extraction of scandium with low impurity co-extraction and scrubbing reagent to remove the extracted impurities from the loaded organic phase. In the first part, different organic reagents that are DEHPA, Cyanex 272, Cyanex 923, I...
Experimental Investigation of Particle-Filler Distribution in Continuous Fiber-Reinforced Composites Produced via Liquid Molding
Aydil, T.; Tanabi, H.; Erdal Erdoğmuş, Merve (2013-09-11)
This paper presents the preliminary results of an experimental study undertaken to investigate the particle distribution in particle-filled, continuous fiber-reinforced composites produced via two liquid molding methods: Resin Transfer Molding (RTM) and Compression Resin Transfer Molding (CRTM). Composite specimens are produced and characterized to compare composite microstructures (particle filler distributions) obtained in each method, as well as to study the effect of a processing parameter (injection sp...
Microwave assisted extraction of phenolic compounds from tomato and sour cherry pomaces
Şimşek, Meriç; Şümnü, Servet Gülüm; Department of Food Engineering (2010)
The objective of this study was to compare microwave assisted extraction (MAE) and conventional extraction methods for the extraction of total phenolic compounds (TPC) from tomato and sour cherry pomace. Antiradical efficiency (AE) of the extracts and also the concentration of phenolic compounds were determined. In MAE, the effects of microwave power (400 and 700 W), solvent type (water, ethanol and ethanol-water mixture at 1:1 v/v), extraction time (8-20 min) and solvent to solid ratio (10, 20 and 30 ml/g)...
Citation Formats
Y. Huang et al., “Micro-CT and nano-CT analysis of filling quality of three different endodontic sealers,” DENTOMAXILLOFACIAL RADIOLOGY, pp. 0–0, 2017, Accessed: 00, 2020. [Online]. Available: https://hdl.handle.net/11511/63046.