Aggregate production planning and material requirements planning systems design for an electronics company

Download
012881.pdf
1991
Türeç, Ayşe
Show full item record
161
views
0
downloads
https://hdl.handle.net/11511/6335
Graduate School of Natural and Applied Sciences, Thesis

Suggestions

Numerical Validation of a Pyroshock Test System and Application to Qualification Tests
Yalçınkaya, Tuncay; Gursoy, Bahadir (2022-08-01)
Spacecraft are exposed to severe mechanical loads, i.e., shock loads, during their journey to orbit. Such loads usually develop due to a separation event through the activation of pyrotechnic devices. They might be transmitted throughout the entire structure and strongly influence the service performance of electronic components. Therefore, it is crucial to study whether the instruments can resist such a harsh environment. However, due to the vulnerability and high cost of the equipment, experimental setups...
Pseudo-Dynamic Testing, Performance Assessment, and Modeling of Deficient Reinforced Concrete Frames
Sucuoğlu, Haluk; Binici, Barış (2014-09-01)
A pair of half-scale, three-story, three-bay concrete bare frames were tested by the pseudo-dynamic (PsD) testing procedure. Both frames represent common deficiencies. of non-seismic construction. Continuous column reinforcement in one specimen and insufficient lap splices at the bottom ends of columns in the other specimen were the only significant differences. Measured seismic performances of both frames were assessed by using the rotation and strain-based acceptance criteria of two different seismic code...
Uncertainty Analysis of Heat Transfer Predictions Using Statistically Modeled Data From a Cooled 1-1/2 Stage High-Pressure Transonic Turbine
Kahveci, Harika Senem (ASME International, 2014-06-01)
This paper compares predictions from a 3D Reynolds-averaged Navier-Stokes code and a statistical representation of measurements from a cooled 1-1/2 stage high-pressure transonic turbine to quantify predictive process sensitivity. A multivariable regression technique was applied to both the inlet temperature measurements obtained at the inlet rake, the wall temperature, and heat transfer measurements obtained via heat-flux gauges on the blade airfoil surfaces. By using the statistically modeled temperature p...
Cooperative relaying schemes for narrow-band frequency hopping wireless ad hoc networks
Yenihayat, Güven; Onat, Furuzan Atay; Kolaǧasioǧlu, Ertuǧrul; Yılmaz, Ali Özgür (2011-08-29)
Cooperative relaying is a promising technique for improving the performance of weak communication links in wireless networks by exploiting spatial diversity induced by relay transmissions. This paper considers cooperative relaying schemes for a narrow- band frequency hopping system. A novel hybrid relaying scheme called opportunistic hybrid relaying, which is specifically designed for this system, is presented. Unlike most relaying schemes in the literature, opportunistic hybrid relaying uses bandwidth effi...
Coherent detection of target signals in non gaussian clutter
Bayrakeri, Sadık; Kuzuoğlu, Mustafa; Department of Electrical and Electronics Engineering (1990)
Citation Formats
A. Türeç, “Aggregate production planning and material requirements planning systems design for an electronics company,” Middle East Technical University, 1991.
METU IIS - Integrated Information Service open@metu.edu.tr