Modeling of Multi Open Phase Fault Condition of Multi-phase Permanent Magnet Synchronous Motors

2011-09-10
Fei, Marco
Zanasi, Roberto
This paper deals with the modeling of multi-phase permanent magnet synchronous motors under multi open phase fault condition. The presented model is suitable for generic number of phases, generic shape of the rotor flux and generic number of open circuit faults. The motor model in fault condition can be used for faults occurring on both adjacent and not adjacent phases. The model can be very useful both for simulation and implementation of fault-tolerant control strategies.

Suggestions

Self excitation of induction motors compensated by permanently connected capacitors and recommendations for IEEE Std 141-1993
Ermiş, Muammer; Cadirci, I; Zenginobuz, G; Tezcan, H (2000-10-12)
Self-excitation of induction motors compensated by permanently-connected capacitors is investigated in this paper. Theoretical analyses of self-excitation phenomenon are carried out by using some simplified equivalent circuits, and a hybrid mathematical model in ABC/dq axes, respectively in steady-state, and transient-state. An unusual operating condition about water pumping stations is reported, in which water within the pipeline may drive the motor in the reverse direction at speeds higher than synchronou...
Target damage level assessment for seismic performance evaluation of two-column reinforced concrete bridge bents
Yilmaz, Taner; Caner, Alp (IOS Press, 2012-01-01)
Displacement capacity verification analysis is usually used to evaluate the level of displacement at which structural elements reach their inelastic deformation capacities. In engineering practice, a modified version of displacement capacity analysis is used in the seismic performance assessment of bridge structures as an alternative to ductility and drift based approaches. In this seismic performance evaluation for a given target damage level, top bent displacement demand should not exceed a certain fracti...
Seismic Retrofit of Deficient RC Structures with Internal Steel Frames
ÖZÇELİK, RAMAZAN; Akpinar, Ugur; Binici, Barış (2011-12-01)
This paper describes an experimental study on internal steel frames (ISFs) to retrofit seismically deficient reinforced concrete (RC) frames. One reference and six strengthened frame specimens were tested under constant gravity load and cyclic lateral displacement excursions. Installation of the ISF with and without anchors to the RC frame was examined. Test results showed that the snug tight ISF installed inside an RC frame may suffice to realize the benefit of implementing ISFs. If the horizontal shear st...
Modelling of strengthened hollow brick infills
BARAN, MEHMET; Ozcelik, Ramazan; Sevil, Tugce; Canbay, Erdem (2013-02-01)
Strengthening the existing hollow brick infill walls by bonding high-strength precast concrete panels or applying steel fibre reinforced mortar was found to be an occupant-friendly seismic retrofitting technique for the buildings in use with deficient reinforced concrete structural systems. Both techniques convert the existing non-structural hollow brick infill walls into load-carrying structural members. To verify the effectiveness of the techniques, 20 reinforced concrete frames with hollow brick infill w...
Pseudo dynamic test of a deficient reinforced concrete frame upgraded with internal steel frames
ÖZÇELİK, RAMAZAN; Binici, Barış; Kurç, Özgür (2013-04-01)
Two-story, three-bay reinforced concrete (RC) frames with and without internal steel frame (ISF) retrofits were tested using continuous pseudo dynamic test method. The ISFs were installed to the middle bay of the RC frame. Test results indicated that ISF retrofit was beneficial in resisting deformation demands without significant damage under simulated ground motions. The ISF shifted the failure mode of the system from a brittle to a ductile mode. The test results were compared with the results of the nonli...
Citation Formats
M. Fei and R. Zanasi, “Modeling of Multi Open Phase Fault Condition of Multi-phase Permanent Magnet Synchronous Motors,” 2011, p. 368, Accessed: 00, 2020. [Online]. Available: https://hdl.handle.net/11511/66115.